Dacor EOR Installation Instructions Manual

Also see for EOR series: Use and care manual Installation instructions Installation instructions Use and care manual Planning guide

Contents

Dacor EOR Installation Instructions Manual Manual pdf 8 page image

6Installation SpecificationsInstallation PlanningWARNINGObserve all governing codes and ordinances during plan-ning and installation. Contact your local building depart-ment for further information.IMPORtANtLocate the junction box so that the oven may be easily•disconnected in the event that it needs to be removedfrom the wall completely for service.If the oven is not installed level it may deliver poor or•inconsistent baking results.A qualified technician must complete the installation of•this built-in appliance. Proper installation is the respon-sibility of the customer.Carefully check the location where the oven is to be•installed. The oven should be placed for convenientaccess. Make certain that electrical power, meetingthe specifications on page 4, can be provided in theselected location.Minimum Interior Cabinet Depth: 24” (61.0 cm)Dacor recommends installing the electrical junction box•in the one of the locations shown.Install the junction box in a location that allows the oven•to be removed from the the cut out for service withoutbeing disconnected.Plan the installation so that all minimum clearances are•met or exceeded. Dimensions shown provide mini-mum clearances, unless otherwise noted. Be certainthat proper clearance is provided for the oven doorwhen it is in the open position according the ProductDimensions.Cabinet cutout dimensions must be used as indicated.•The specified minimum cabinet depth and width mustbe provided. The cabinet depth and width must com-pletely enclose the recessed portion of the oven.All contact surfaces between the appliance and the cabi-•net must be solid and level.Provide a platform within the cabinet to support the•oven. It must be installed level and straight. The topedge of the platform must be flush with the cut out atthe front of the cabinet. There are no provisions to levelthe oven after it has been installed. 3/4” (1.9 cm) thickplywood is recommended.ModelNumberMinimum CabinetWidth (N)Minimum Cut OutWidth (P)Minimum Cut outHeight (R)EORS127/MORS127 27” (68.6 cm) 25 ½” (64.8 cm)27 5/8” (70.2 cm)EORS130/MOCS130 30” (76.2 cm) 28 ½” (72.4 cm))EORS136 36” (91.4 cm) 34 ½” (87.6 cm) 27 ¾” (70.5 cm)EORX227/MORX227 27” (68.6 cm) 25 ½” (64.8 cm)49 1/8” (124.8 cm)EORX230/MORX230 30” (76.2 cm) 28 ½” (72.4 cm)Cabinet DimensionsX = Number of convection ovens, see page 3