Preparing for InstallationWARNINGIf the gas or electric service provided does not meet theproduct specifications, do not proceed with the installation.Call the dealer, the gas supplier or a licensed electrician.Before installing the range, you must locate and secure theanti-tip bracket to the floor.••IMPORTANT: Within the Commonwealth of Massachusetts, thisappliance must be installed by a licensed plumber or gas fitter.Unpack the RangeUnpack the parts box and verify that all required componentshave been provided. If any item is missing or damaged, pleasecontact your dealer immediately. Do not install a damaged orincomplete appliance. The customer must report cosmetic issueswithin 30 days of installation.Parts List3 Grates2 Small Stack Burner Caps2 Small Stack Burner Rings2 Large Stack Burner Caps2 Large Stack Burner Rings2 Crown Burner Caps2 Crown Burner Rings2 Crown Burner Heads1 GlideRack ™ Oven Rack2 Standard Size Racks3 18” Racks (ER48D only)•••••••••••6 KnobsAnti-tip Bracket w/ScrewsMeat ProbeGriddleWok RingStainless Steel CleanerPry StickLiterature KitIgnitor Cleaning BrushBroiler Pan/Grill••••••••••See the use and care manual for a list of optional parts andaccessories.NOTE: The range also includes a thread ring removal tool for thecrown burners (PN101539). It is taped in place behind the rightside of the kick panel when the range is shipped from the factory.Leave it in place unless the spill trays need to be removed forservice. Return it after use so that it is available if needed in thefuture.Installation InstructionsWARNINGDo not connect the unit to gas or power before proceeding withthe following sections.Level and Adjust the Range HeightAdjust the height by turning the bottom part of each legas shown. Raise or lower the range until the trim aroundthe cooktop area is slightly higher than the counter-top. Ifinstalling with a raised vent, adjust the height so that the trimmatches the height of the vent’s top in the down position.Use a level to make sure that the range does not tilt front toback or side to side. Readjust the legs if necessary.Install the Anti-Tip Bracket and FootLocate the anti-tip foot and lower it until it is 1/16" (2mm) offthe floor. See the bottom left diagram.Locate the anti-tip bracket included in the parts box.Install the anti-tip bracket on the floor using the four includedscrews. The mounting location varies according to the model.See the diagram below for location.ANTI-TIP BRACKET PLACEMENTDimension ER36D ER48DJ 7 1/2” (191mm) 19” (483mm)K 6 1/2” (165mm) 6 1/4” (159mm)1.2.1.2.3.JKTop viewBack of Range RangeRight SidePanelBack of RangeAnti-Tip Foot(location varies)1 1/4” *downupRear LegThread Ring RemovalTool Location* Distance to floor: 4 1/16” to 5 5/16”