Dacor Epicure OB36 Installation Instructions Manual

Also see for Epicure OB36: Use and care manual Use & care manual Planning guide Use and care manual Planning guide

Contents

Dacor Epicure OB36 Installation Instructions Manual Manual pdf 19 page image

176. If the second or third attempt to ignite the burner isnot successful then turn all burner controls to the offposition.7. If the grill or cooktop fails to operate properly, makesure that power to the electrical outlet and gas supplyare turned on and that all installation steps have beencarefully followed. Check also for a tripped groundfault interrupter on the electrical outlet. Push in on theRESET button.noTe: If using an extension cord, the igniters willnot spark properly if the cord is not supplying a solidground.If the grill still will not light, close the gas shut-off valve. Donot attempt to repair the appliance yourself. Contact DacorDistinctive Service at (877) 337-3226. Have the model andserial number from the product data label available whenyou call.Dacor is not responsible for the cost of correcting problemscaused by a faulty installation.Installation Checklistwarning• To ensure a safe and proper installation, the follow-ing checklist should be completed by the installer toensure that no part of the installation has been over-looked.• Proper installation is the responsibility of the hom-eowner. The importance of proper installation of yourDacor Outdoor Grill cannot be over emphasized.□ Is the electrical outlet for the appliance grounded andlocated according to these instructions and in accor-dance with all applicable electrical codes for outdoorappliances?.□ Is the gas service for the appliance located andinstalled according to these instructions and in accor-dance with all applicable codes?□ Has the gas supply inlet pressure been measured toensure that it does not exceed the maximums andmeets the minimum stated in these instructions?□ Is the appliance secured to the cabinet or cart?□ Are the grease tray, flame spreaders, grates and, ifapplicable, burner heads and caps properly installedaccording to these instructions?□ Has proper operation been verified? Did the installercheck the gas supply for leaks?□ Have any problems been noted on the warranty cardor during the on-line warranty activation? Has the war-ranty been activated on-line or the warranty card filledout completely and mailed?2. With the tank shelf open, connect the power cord fromthe outdoor grill and the warming oven (if equipped withone) to the electrical outlet on the back panel inside thecart.3. Connect the rotisserie motor power cord to the electri-cal outlet on the back side of the cart.Power Connection - Cabinet Installations• Connect the appliance(s) to an electrical outletthat meets the specifications in the Planning theInstallation section.• The rotisserie motor should be plugged into the sameoutlet or an alternate 120 Vac outlet on the same circuitas the appliance.Verifying Proper OperationLighting Instructions1. Read and understand the accompanying use and caremanual prior to cooking with this appliance. The useand care manual contains additional important safety,service and warranty information.2. No adjustment of burner settings is required. All valvesand air mixture shutters found in this appliance havebeen factory preset.3. With the gas shut-off valve open, turn allburner knobs to the high position forapproximately 20 seconds to allow the airin the system to purge from the grill andcooktop side burners.4. Once the gas has filled the lines the auto-matic electronic ignition system shouldignite the burner. If the system burnersdo not ignite within 20 seconds turn allburner controls to the off position. Waitfive minutes and attempt the ignition pro-cess again.5. Visually check the burner flame for proper operation.Proper flame operation will show a steady, soft bluecolor and stable flame.Installation Instructionselectrical outlet with ground fault interrupterOFFHIGH