Dacor In-A-Drawer MMD24 Installation Instructions Manual

Also see for In-A-Drawer MMDV30S: Use and care manual Use and care manual Installation instructions and owner's manual Installation instructions Installation instructions

Contents

Dacor In-A-Drawer MMD24 Installation Instructions Manual Manual pdf 5 page image

E3Design SpecificationsABCD EFG HIIJKLMNOPQABCFIDHGEAJABCD EFG HI KABCFIDHGEABC DEJCLEARANCES ANDDIMENSIONS• Dimensions that are shown in Figures 2, 4and 5 must be used. Given dimensions provideminimum clearance. Locate the electrical outletin the shaded area in the upper left-hand cornerof the cutout. See Figure 8.• The contact surface must be solid and level.Pay special attention to the floor on which thedrawer will sit. The floor of the opening should beconstructed of plywood strong enough to supportthe weight of the unit (about 100 pounds).24" DRAWER MEASUREMENTSFigures 1 and 2 contain many Microwave In-A-Drawer™measurements for reference when planning the drawer’slocation.• Check the location where the drawer will beinstalled for proper electrical supply.• Your oven can be built into a cabinet or wall byitself or under any gas or electric wall oven.• Be sure that the clearance of the floor betweenthe wall oven and the drawer is a minimum of 2".• For updates of approved appliances that can beused adjacent to the Microwave In-A-Drawer™ goto www.Dacor.com.Figure 2A. 6"B. Electrical outlet locationC. anti-tip blockD. 5"E. 3 ½"F. 4"G. 22 ¼" openingH. 14 ¾" to bottom of anti-tip blockI. Allow 7/8" minimum overlapJ. 23 ½" minimum depthK. Allow 3/16" minimum overlapL. 36" nominal countertop heightM. Allow 7/16" minimum overlapN. Floor must support 100 lbs.O. 19" to top of floor (recommended)P. *24" cabinet minimumQ. 15 3/16" ± 1/16" openingNOTE: Open Top Cabinet illustratedFigure 1A. 21 19/32"B. 4 11/16"C. 1 23/32"D. 23 3/8"E. 23 13/16"F. 15 5/8"G. 15 1/16"H. 1" door thicknessI. 15" auto drawer openingJ. 48" power cord length