Dacor In-A-Drawer MMD24 Installation Instructions Manual

Also see for In-A-Drawer MMDV30S: Use and care manual Use and care manual Installation instructions and owner's manual Installation instructions Installation instructions

Contents

Dacor In-A-Drawer MMD24 Installation Instructions Manual Manual pdf 7 page image

E5Design SpecificationsANTI-TIP BLOCKNORMAL INSTALLATION STEPSANTI-TIP BLOCK INSTALLATION INSTRUCTIONSTo reduce the risk of tipping the drawer, the anti-tip blockmust be properly installed 14 ¾" above the floor cutout.The 6" anti-tip block must be provided by the installer.See Figures 2 and 6 for (24") or Figures 4, 5, and 6(for 30"). The anti-tip block prevents serious injury thatmight result from spilled hot liquids.If the drawer is moved to a different location later, theanti-tip block must also be moved and installed. Wheninstalled to the wall, make sure that the screws completelypenetrate the dry wall and are properly secured into theVERIFYING PACKAGECONTENTS• Remove all packing materials from inside thedrawer. DO NOT REMOVE THE WAVEGUIDECOVER, which is located inside, on the ceiling ofthe Microwave In-A-Drawer™.WaveguideCoverSealingSurface• Remove the feature sticker, if there is one. Checkthe drawer for any damage, such as misaligned orbent drawer, damaged drawer seals and sealingsurfaces, broken or loose drawer guides anddents inside the cavity or on the front side of thedrawer. If there is any damage, do not install oroperate the Microwave In-A-Drawer™ and contactyour dealer or a DACOR AUTHORIZED SERVICER.SealingSurfaceOvenCavityFigure 7ELECTRICAL OUTLET4"5"electrical outletlocationFigure 8The electrical requirements are a 120 volt 60 Hz, AConly, 15 amp. or more protected electrical supply. Itis recommended that a separate circuit serving onlythis appliance be provided.The drawer is equipped with a 3-prong groundingplug. It must be plugged into a wall receptacle thatis properly installed and grounded. Should you onlyhave a 2-prong outlet, have a qualified electricianinstall a correct wall receptacle.NOTE:If you have any questions about the grounding orelectrical instructions, consult a qualified electricianor service person.base material underneath so that the block is totallystable. When fastening, be sure that the screws do notpenetrate electrical wiring or plumbing.4"5"electrical outletlocation anti-tipblock(6")Figure 6Installation Instructions