Dacor Preference SGM304 Installation Instructions Manual

Also see for Preference SGM304: Planning guide Combination installations Planning guide Installation instructions Planning guide

Contents

Dacor Preference SGM304 Installation Instructions Manual Manual pdf 6 page image

4Cabinet and Countertop LayoutWARNINGTo reduce the risk of personal injury caused by•reaching over a hot appliance, avoid locatingcabinet storage space directly above the cooktop.To reduce the risk of a fire hazard, observe all•specified clearances.The back edge of the cooktop must be located a•minimum of 2 1/4” (57mm) from any combustiblebacksplash material. Special cabinet andcountertop dimensions may be required.Follow the countertop manufacturer’s instructions•regarding the minimum corner radius, use of heatreflective tape, reinforcement of corners, etc.The cooktop is designed for a 24” (610 mm) minimum•base cabinet depth.Carefully check the location where the cooktop will be•installed. For best performance, the cooktop should beplaced away from drafts that may be caused by doors,windows and heating and air conditioning outlets.Plan the installation so that all clearances shown below•are met or exceeded. Dimensions shown provideminimum.Model A: Minimum A: RecommendedSGM304 30” (762mm) 36” (914mm)SGM365 36” (914mm) 42” (1067mm)SGM466 48” (1219mm) 54” (1372mm)InstallatIon sPecIfIcatIonsAllow a minimum ¼” (6mm) clearance between the•bottom of the cooktop chassis and all combustiblesurfaces, including the upper edge of a drawer installedbelow the cooktop.Model B: MinimumSGM304 29” (737mm)SGM365 35 1/4” (895mm)SGM466 46” (1168mm)The gas supply piping, gas shut-off valve and the electricaloutlet must be located so they do not interfere with thecooktop when it is installed. If installing another appliancein the cabinet below, allow for the routing of gas andelectrical service behind it.The installation must allow for the following:Access to the gas shut-off valve and regulator when•the unit is installed.Access to the electrical outlet when the cooktop is in•place. The 40” (1016 mm) power cord must be able toreach the electrical outlet.Access to the underside of the cooktop for service and•inspection purposes.Clearance inside the cabinet to allow for proper hold•down bracket installation.To allow access to the utilities and cooktop bottom, a fixedshelf should not be installed below the cooktop.Parts ListProduct literature•Hold down brackets (2)•Cleaning kit•Simmer plate•Grates•SGM304 - 2 large◊SGM365 - 2 large, 1 small◊SGM466 - 3 large◊Burner cap and ring sets•SGM304 - 1 large set, 1 medium set, 2 small sets◊SGM365 - 1 large set, 2 medium sets, 2 small sets◊SGM466 - 2 large sets, 1 medium set, 3 small sets◊Gas pressure regulator (Type/size varies with model)•1/4” (6mm)Mimimum clearanceto combustiblesurfacesBUnder Cabinet Clearances - Front View13"(330mm)Max.A3 1/8" Min.(79mm)30"(762mm)Min.Clearances to Combustibles18"(457mm)Min.All tolerances +1/16” -0 (+1.6 mm, 0)unless otherwise noted.