Dacor RNHP30 Renaissance Installation Instructions Manual

Also see for RNHP30 Renaissance: Use and care manual Installation instructions Installation instructions Use and care manual Use and care manual

Dacor RNHP30 Renaissance Installation Instructions Manual Manual pdf 23 page image

21Installation InstructionsHanging the Range HoodWARNINGHanging the range hood requires two people. Do not attempt to lift the hood without assistance.When hanging the hood, be careful not to scratch or dam-age the hood.1. Remove the plastic film from the hood.There are hanging slots in the back of the hood a fewinches from the top. The holding brackets on the wallengage here and temporarily hold the hood in place.2. Lift the hood up and catch holding brackets in thehanging slots in the back of the hood (see figureHanging the Hood).3. Adjust the hood into its final position.4. Mark the spot by drawing in a mounting hole in theback of the hood (see figure Hanging and MountingSlots ). This is where a screw will hold the hood to thewall stud or (concrete) anchor.5. Mark the top of the hood if the configuration calls forthe hood to be secured at the top.6. Remove the hood from the wall.7. Drill the pilot or anchor holes. If using anchors, insertthem into the anchor holes.8. Reattach the hood to the holding brackets.9. Adjust the hood into its final position and fasten it intoplace:Insert the fasteners through the mounting slots in theback and top of the hood and into the studs, mountingblocks, or anchors.Holding bracketsHanging the HoodHanging and Mounting SlotsHanging slots in theback of the hoodMounting slots