Dacor Renaissance RNRP36GS Installation Instructions Manual

Also see for Renaissance RNRP36G: Planning guide Planning guide

Contents

Dacor Renaissance RNRP36GS Installation Instructions Manual Manual pdf 5 page image

3Planning the InstallationWARNING• IMPORTANT: Observe all governing codes and ordinancesduring planning and installation. Contact your local buildingdepartment for further information.• To prevent an electric shock hazard, the power supplymust meet the specifications stated below. It is the owner’sresponsibility to make sure that the electrical service meetselectrical requirements and that the electrical outlet hasbeen properly installed by a licensed electrician.The appliance installation must be electrically grounded inaccordance with local codes or, in the absence of local codes,with the National Electrical Code, ANSI/ NFPA 70:Electrical Requirements• The range is supplied with a factory installed, 6 foot long,power cord with a three-prong grounding plug. It is connectedto the chassis at the rear of the range. It must be connectedto a dedicated, grounded three-prong electrical outlet.• The correct voltage, frequency and amperage must besupplied to the appliance from a separate, grounded, circuitthat is protected by a properly sized circuit breaker or timedelay fuse.Model Circuit RequiredTotalConnectedLoad*RNRP36G 120 Vac, 60 Hz, 15 Amp. 120 Vac 60 Hz,5.0 Amp.RNRP48G 120 Vac, 60 Hz, 15 Amp. 120 Vac 60 Hz,8.0 Amp.*These specifications for reference only. Refer to the rating labelfor exact specifications (see below for location).Gas Supply Requirements• The installation of this appliance must conform with localcodes or, in the absence of local codes, with the NationalFuel Gas Code, ANSI Z223.1/NFPA 54.• Be certain that the appliance being installed is correct forthe gas service provided (natural gas or LP gas). Also, ifoperating the range at an altitude above 4000 ft. (1219 m)make sure it is equipped for high altitude operation. Referto the range rating label and the table on the inside cover todetermine the correct model.• See the table below for gas supply pressure requirements.• The range comes from the factory with the regulatorinstalled. Use only the installed regulator. The regulator inletaccommodates a 3/4” gas line. The range ships with a 1/2” to3/4” adapter connected to the regulator.GAS SUPPLY PRESSURE REQUIREMENTS*Gas Type MinimumManifold PressureMinimum GasSupply Pressure**Natural Gas 5” Water Column 6” Water ColumnLiquid Propane (LP) 10” Water Column 11” Water Column* The gas supply pressure for testing the regulator setting shallbe at least 1 inch water column (249 Pa) above the specifiedmanifold pressure.** Maximum gas supply pressure for all models: 1/2 psi.The ratings above are for reference only. Refer to the rating labelfor exact specifications (see below left for location).BAPowercordGasInletGAS - ELECTRICAL ACCESS DIMENSIONSModel A BRNRP36G 13 1/16” to 14 3/8”(33.2 to 36.5 cm)7 5/16”(18.6 cm)RNRP48G 13 1/16” to 14 3/8”(33.2 to 36.5 cm)4 1/4”(10.8 cm)Specifications Label LocationView rating label through slot ontop of kick panel through openingbetween door and range