Dacor Renaissance RNRP36GS Installation Instructions Manual

Also see for Renaissance RNRP36G: Planning guide Planning guide

Contents

Dacor Renaissance RNRP36GS Installation Instructions Manual Manual pdf 8 page image

6Preparing for InstallationWARNING• If the gas or electric service provided does not meet theproduct specifications, do not proceed with the installation.Call the dealer, the gas supplier or a licensed electrician.• Before installing the range, you must locate and secure theanti-tip bracket to the floor.IMPORTANT: Within the Commonwealth of Massachusetts, thisappliance must be installed by a licensed plumber or gas fitter.Unpacking the RangeUnpack the parts box and verify that all required componentshave been provided. If any item is missing or damaged, pleasecontact your dealer immediately. Do not install a damaged orincomplete appliance.Installation InstructionsParts List- 3 Grates- 8 Standard burner caps(4 brass, 4 porcelain)*- 4 Standard burner rings- 4 SimmerSear burner caps(2 brass, 2 porcelain)*- 2 SimmerSear burner rings- 2 SimmerSear burner heads- 2 GlideRack™ oven racks- 1 Standard rack- 2 GlideRack™ 18” wide ovenracks (RNRP48G only)- 1 18” wide standard oven rack(RNRP48G only)- Knobs (4 Standard cooktop,2 cooktop MAX GRIDDLE,1 oven for RNRP36G,2 oven for RNRP48G)- Anti-tip bracket with screwsand anchors- Griddle- Wok ring- Stainless steel cleaner- Literature kit- Broiler pan/grill*The range is supplied with two different types of burner caps(brass and porcelain) to suit the customer’s preference. Pleasenote that the brass burner caps change color over time as theresult of heat.Installing a 9 Inch Backguard (Optional)Install the optional 9 inch backguard before making the rangegas and electrical connections. Install it according the installationinstructions included with the backguard kit.Approved backguard kits:Model DescriptionAPB36D9 9 inch high backguard for range model RNRP36GAPB48D9 9 inch high backguard for range model RNRP48GInstall the Anti-Tip Bracket and FootLocate the anti-tip bracket included in the parts box.There are two ways to mount the anti-tip bracket:• Floor mounting (preferred method)• Wall mounting (alternate method). Use this method if floormounting is not suitable. If the front panel of range (excludingbull nose) is further than 27” (68.6 cm) from the back wall or ifthe flooring is too thick (see Installing the Anti-Tip Bracketon the Wall), the wall mounting method may not be used andthe floor mounting method must be suitable.Installing the Anti-Tip Bracket on the FloorWARNINGTo perform its intended function, the anti-tip bracket must beattached as instructed to the concrete slab or wood sub-floorbelow any floor coverings (including cement board) on top. Donot attach the anti-tip bracket directly to floor coverings such asceramic/asphalt tile or linoleum.Four (4) plastic anchors are provided along with three sizes (4each) of #8 or #12 Phillips head screws for attaching the anti-tip bracket to the floor. Use both the anchors and four (4) of thescrews when attaching the bracket to a concrete sub-floor. Do notuse the provided anchors when attaching to a wood sub-floor.Sub-floorScrews attached tosub-floor below floorcoveringAnti-tipbracketFloorcoveringConcrete anchors shown, donot use for wood sub-floor