Dacor Renaissance RNTT365GB Use And Care Manual

Also see for Renaissance RNTT365GB: Installation instructions Planning guide

Contents

Dacor Renaissance RNTT365GB Use And Care Manual Manual pdf 14 page image

12Before You Call for ServiceDisplay CodesBurner Control Display CodesThese codes may appear on one or more of the burner control displays.Code What it Means What to Do“b” = a burner is locked.Burner failed to light afterthree tries.Reset burner according to instructions onpage 7. If error code occurs again, seeNo flame on following page.“F”=Flame abnormality.Safety sensor for that burnerhas detected abnormal flame.Check to make sure the burner ring andburner cap(s) are properly assembled. Resetburner according to instructions on page7. If error occurs again, call for service.Burner is (very) HOT.Not an error code. “H” warns the user thatthe burner is HOT after use. “H” will disap-pear after the burner has cooled.Clock Display CodesThese codes may appear on the clock display.Error Code What it Means What to DoFlt00, Flt01, Flt02,Flt03, Flt04, Flt04,Flt05System malfunction detected Unplug the power cable for 10seconds, then reconnect. Attempt tooperate cooktop normally. If errorcode occurs again, disconnect powerand call for service.Flt06 Limit of 5 burner resets in 15minutes exceeded.Wait 15 minutes for error code toclear. Troubleshoot cooktop operationaccording to No flame section onfollowing page, then perform aburner reset if necessary. If one ormore burners continue to not light,disconnect power and call for service.Flt08, Flt09 System malfunction detected. Unplug the power cable for 10seconds, then reconnect. Attempt tooperate cooktop normally. If errorcode occurs again, disconnect powerand call for service.Flt0A All burners are locked. Try to reset burners according toinstructions on page 7. If controlpanel will not reset, unplug the powercable for 10 seconds, then reconnect.If error code occurs continues, unplugpower and call for service. If errorcode clears, check No flame on fol-lowing page before attempting to useappliance again.Flt0[, Flt0E System malfunction detected Unplug the power cable for 10seconds, then reconnect. Attempt tooperate cooktop normally. If errorcode occurs again, disconnect powerand call for service.