Daewoo DTQ-14Q1 Instruction Manual

Also see for DTQ-20T3: Service manual Instruction manual

Once you have connected your TV to an antenna or cable system, plugged the TV in,and put batteries in the remote, you are ready to use the TV. The first thing you shoulddo is program your TV so it memorizes all of the available channels.Turning Your TV On1 To turn your TV on, press the POWER button on the remotecontrol. You can also use the POWER button on the frontpanel. Make sure your TV is plugged in before you try to turnit on.Programming Your TV's Channel MemoryYour TV's memory determines the channels that are available using the WCHV but-tons. If a channel is not in memory, you can tune to it with the number buttons, but notwith the WCHV buttons. Follow these steps to program your TV's memory:1 With the TV turned on, press the MENU button.2 Use the WCHV buttons to select Setup, and press the CVOLB buttons.3 Use the WCHV buttons to select Auto Program, and press the CVOLB buttons.4 Use the WCHV buttons to select Source, then use the CVOLB buttons to selectAir or Cable.5 If you connected an antenna to your TV, select Air; if you connected a cable sys-tem, select Cable.6 Use the WCHV buttons to select Auto Program, and press the CVOLB buttons todisplay Auto Program.7 If you exit Auto Program, press the MENU button.Your TV's channel memory will not be affected by a power outage. You will not needto re-program the memory unless you change the type of cable antenna connected toyour TV.Operating Your TV11Chapter 3 : Operating Your TVC H A P T E R 311 3 SetupVideoTimerLPrev WVMove CBSelect2 SetupVideoTimerLPrev WVMove CBSelect4 SetupAuto Program CBTo PressEdit ProgramFavorite ChLanguageCaptionsPower RestoreInputL Prev WVSelect CBAdjust