36Daewoo Video Cassette Recorder User’s Guide35 Daewoo Video Cassette Recorder User’s Guideside of the remote sensor centre and no more than23 feet from the VCR.• Make sure there is no obstruction between theremote control and the VCR.Timer clock does not work.• Make sure the VCR is plugged in and receivingpower.• If the unit has been without power for some periodof time, you must reset the clock and all your timerprograms.Video cassette won’t go into the cassettecompartment.• Make sure there is not a tape already loaded into thecassette compartment.• Insert the video cassette with the label side up.VCR and remote control buttons don’t work.The REW button does not work at the very beginning of avideo cassette. The FF, PLAY and REC/OTR buttons do notwork at the end of a video cassette.Emergency indicator ‘Err’ is appearing.Press POWER to disappear the indicator appeared. If theemergency indicator continues to appear, contact aservice technician.The VCR buzzes when it is on.The VCR may be in standby mode and the motor isrunning. This sound is normal.Video cassette recorder doesn’t rewind all the wayto the end.To avoid video cassette tape damage, the VCR stopsrewinding near the end of the tape and then slowlyfinishes rewinding. Do not prematurely eject the tape.Troubleshooting,continuedTroubleshooting Your Daewoo VCR is designed to give you trouble-freeperformance for many years. If you have a problem withyour VCR, try the solutions listed below.If the suggestions listed below do not solve your problem,contract your Daewoo dealer or an authorized Daewooservice center. You can also call Daewoo directly at1-800-DAEWOO8(1-800-323-9668).The front panel display is blank.Make sure the VCR is plugged in.The power is on but the VCR does not operate.Make sure there is a video cassette inserted in the VCR.A timer recording failed to record on the videocassette.• Make sure the video cassette’s safety tab is in place.• Verify that you set the timer correctly.• Make sure there is a video cassette in the VCR.• Make sure the VCR is plugged in.Picture quality during playback is poor.• Adjust the picture quality by pressing –CH/TRK+.• The head may be dirty. Use a head-cleaning tape.Picture does not appear when you attempt to playa video cassette.• Make sure the TV and VCR are set to the samechannel (channel 3, 4 or video input).• Verify the connections between the VCR and the TV.• Verify that the VCR indicator is lit on the front display.Remote control doesn’t work.• Make sure the batteries are fresh.• Make sure that you are using the remote controlwithin the operational range-no more than 30° either