C H A P T E R 29Chapter 2 : Connecting an Antenna or Cable to Your TV/VCRConnecting an Antenna or Cable to Your TV/VCRYour TV/VCR will provide you with the best performance if you connect it to an externalantenna or cable system. Follow the directions below make this connection. Please note thatyou will normally only have to make one of the connections shown below, not all of them.All connections will be made to the antenna terminal on the back of your TV/VCR. Theantenna terminal is a silver metal post partially surrounded by two plastic tabs. For help inlocating the antenna terminal, see “Your TV/VCR's Back Panel” on page 5.There is no antenna provided with your TV/VCR.Connecting an AntennaIf your antenna ends in a single coaxial lead,simply press or screw the cable onto the antennaterminal on the back of your TV/VCR.If your antenna ends in a pair of 300 ohm twin leads, you must use a 300-ohm/75-ohmadaptor. (An adaptor is included with your 13” TV/VCR.) Place the leads underneath thescrews on the adaptor, tighten the screws, then press the adaptor onto the antenna terminal onthe back of the TV/VCR.