OPERATING INSTRUCTIONS9• FAN & COOLING CONTROLThe Fan Control Selector Switch has six positions.Choose one of the speed settings by rotating the fan control Selector Switch to the appropriate position.OFF Select this setting for stop all operation of air conditionerFAN Select this setting for low speed air circulation withoutcooling and heating.LOW COOL Select this setting for cooling operation with LOW FAN.HIGH COOL Select this setting for cooling operation with HIGH FAN.LOW HEAT Select this setting for Heating operation with LOW FAN.HIGH HEAT Select this setting for Heation operation with HIGH FAN.• TEMPERATURE CONTROLChoose a temperature settings by rotating the knob of thermostat to the appropriate position• The Thermostat automatically starts and stops cooling operation in order tokeep the room temperature at a proper level, and this results in efficient use ofpower and economical cooling.• Turn clockwise for a cooler room temperature.• Turn counter-clockwise for a warmer room temperature.• HEATER LAMPWhen the unit sets heating operation condition, the red lamp is lighted.When the frost settles on the heat exchanger of the outside, defrosting is made automatically and the redlamp is turned off.The unit may give a hiss and the fan motor stops for 1 to 10 minutes.This should not be regarded as a problem.After defrosting, the heating operation begins again.NOTE• FOR MOST ECONOMICAL USE1. Properly control the room temperature.2. Avoid the unit being exposed to direct sunlight. Keep direct sunlight from the room.3. Do not leave doors and windows open.NOTESetting the control at the coldest extreme of the temperature range will not cool the room anyfaster. Usually the midpoint is a good starting position. If the room temperature is not satisfactoryafter a reasonable period of time, adjust the temperature control to a lower or higher setting.WARMERCOOLERHIGHCOOLLOWCOOLHIGHHEATLOWHEATFANFANOFFSELECTORWARMERCOOLERTHERMOSTATCAUTIONWhen the air conditioner has been performing its cooling operation and is turned “OFF” or set tothe ‘FAN” position, wait at least 3 minutes before resetting to the cooling operation.