28More FunctionsClock / counter display The counter counts in real time from the point you load the cassette. This does not have to be itsbeginning! The counter does not count unrecorded parts of the tape. If you rewind beyond the zero position, the counter counts in negative values (e.g. – 0:01:15).Each time you press [DISPLAY] button,1x: Time and date+current status Time and date2x: Counter+current status counter3x: disappear.But if you press [CLK/CNT] button, clock and counter on display windowwill change each other.• If didn’t wind tape (PLAY, FF, REW,...), it doesn’t appear the tape remain time.• In case that the timer recording information is inputted in the received broadcasting signal , press the buttonto display the VPS/PDC icon.STOP SP PR01 ARD14:00 14/10 E180 00:48STEREO ONVAccessing counter zero positionThe player will wind to the position 0:00:00 and stop.Remaining time and cassette lengthWhen you want the player to show the time remaining from the current player tape position (to find out ifthere is sufficient space for a recording, for example).To ensure the remaining time shown is accurate, select the length of cassette currently loaded by selectingthis function until you reach the correct length.• Remaining time display isonly possible when thecassette is loaded.TAPE CONTROL TAPE REMAINE-240 01:27TAPE REMAINGO TO ZEROCOUNTER RESETINDEX+INDEX-E-180E-240E-300PR+/-:SELECTOK:CONFIRM SETUP:ENDPR+/-:SELECTOK:CONFIRM SETUP:ENDREW SPGO TO ZERO0:02:13Resetting the counter to zeroReset the counter.COUNTER RESET0:00:00and ...Dimmer : Your player dims its display when switched to stand-by mode.Auto power off : Your player switches to stand-by when no tape is played and no station is received for morethan 5 minutes.