Daewoo SD-3100 Owner's Manual

Also see for SD-3100: Owner's manual

Contents

VCR Operation31Connections and CopyingTo the TV via antenna cable (if you are not using a SCART cable) If you are using a SCART cable, select the AV input on the TV to see the picture from the player. If you are not using a SCART cable, select the button number on the TV reserved for video input tosee the picture from the player.If you are not using a SCART cable, your player can transmit pictures and sound to the TV via the coax aerialcable. Just tune the TV to the player's transmitting channel (factory set to UHF CH 52). Tune the TV carefully toensure the best pictures and sound.Once you have carried out the steps in "Connecting up the player" , switchon your TV.Press the [OK] button of the player’s remote control longer than 5 secondsto call the player´s test picture.Tune the TV to the test picture using the channel pre-set functions of yourTV as described in its manual.When you have found the test picture, store it under the button number onyour TV for player input.Press the [OK] button of the player’s remote control again longer than 5seconds to release the test picture.1• If the quality of the test picture transmitted to the TV is poor due tointerference caused by a station transmitting on channel 52, you can tunethe player to a different transmitting channel. Find a free channelbetween 21 and 69 on your TV.Call the player’s "MAIN SETUP" choose "VCR SETUP" then "RFOUTPUT SET".Type in the free channel.Store and exit.2• If the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV mayhelp (refer to the TV manual).• Without a scart cable, you will not get stereo sound from a TV capable of stereo sound.RF OUTPUT SET0-9:SELECT (21-69)OK:CONFIRM SETUP:ENDCH 52