Dahua N6 2U Series Quick Start Manual

Dahua N6 2U Series Quick Start Manual Manual pdf 27 page image

23z Enable: Check the box here to enable this function.z Storage: This function is null right now.z Frame rate: PAL：1-25fps.NTSC:30fps.z Bit stream value: Default setup is 1024Kb/S.Figure 2-172.5 ScheduleNote:You need to have proper rights to implement the following operations. Please make sure theHDDs have been properly installed.After the system booted up, it is in default 24-hour regular mode. You can set record type andtime in schedule interface.In the main menu, from Setting to Schedule, you can go to schedule menu. See Figure 2-18.There are total six periods.z Channel: Please select the channel number first. You can select “all” if you want to set forthe whole channels.z Week day: There are eight options: ranges from Saturday to Sunday and all.z Pre-record: System can pre-record the video before the event occurs into the file. The valueranges from 1 to 30 seconds depending on the bit stream.z Redundancy: System supports redundancy backup function. You can highlight Redundancybutton to activate this function. Please note, before enable this function, please set at leastone HDD as redundant. (Main menu->Advanced->HDD Management). Please note thisfunction is null if there is only one HDD.z Snapshoot: You can enable this function to snapshoot image when alarm occurs.z Record types: There are four types: regular, motion detection (MD), Alarm, MD & alarm.z Holiday setting: Click it you can see an interface shown as in Figure 2-19. Here you can setholiday date. Check the box, it means current channel shall record as your holiday setup.Please go to the Period interface to set the holiday date record setup. You can enableholiday function on General interface and go to Schedule interface to enable holiday setup ofa channel.