1724 Local Basic Operation4.1 Getting Started4.1.1 Boot up and Shut down4.1.1.1 Boot upWarningBefore the boot up, please make sure: For device security, please connect the NVR to the power adapter first and then connect the deviceto the power socket. The rated input voltage matches the device power on-off button. Please make sure the power wireconnection is OK. Then click the power on-off button. Always use the stable current, if necessary UPS is a best alternative measure.Please follow the steps listed below to boot up the device. Connect the device to the monitor and then connect a mouse. Connect power cable. Click the power button at the front or rear panel and then boot up the device. After device booted up,the system is in multiple-channel display mode by default.4.1.1.2 ShutdownNote When you see corresponding dialogue box “System is shutting down…” Do not click power on-offbutton directly. Do not unplug the power cable or click power on-off button to shutdown device directly when deviceis running (especially when it is recording.)There are three ways for you to log out.a) Main menu (RECOMMENDED)From Main Menu->Shutdown, select shutdown from dropdown list.Click OK button, you can see device shuts down.b) From power on-off button on the front panel or remote control.Press the power on-off button on the NVR front panel or remote control for more than 3 seconds toshut down the device.c) From power on-off button on the rear panel.4.1.2 Device InitializationIf it is your first time to use the device, please set a login password admin (system default user).NoteFor your device safety, please keep your login password of admin well after the initialization steps, andchange the password regularly.Please follow the steps listed below.
