308Here is for you to set proper alarm output (Auto/manual/stop).Click OK button of the alarm reset, you can clear all alarm output status.Figure 4-160Please highlight icon to select the corresponding alarm output.After all the setups please click OK button.4.8 Network4.8.1 Network Settings4.8.1.1 TCP/IPThe single network adapter interface is shown as in Figure 4-161 and the dual network adapters interfaceis shown as in Figure 4-162. Network Mode : Includes multiple access, fault tolerance, and load balancing Multiple-address mode: eth0 and eth1 operate separately. You can use the services such asHTTP, RTP service via etho0 or the eth1. Usually you need to set one default card (default setupis etho) to request the auto network service form the device-end such as DHCP, email, FTP andetc. In multiple-address mode, system network status is shown as offline once one card isoffline. Network fault-tolerance: In this mode, device uses bond0 to communicate with the externaldevices. You can focus on one host IP address. At the same time, you need to set one mastercard. Usually there is only one running card (master card).System can enable alternate cardwhen the master card is malfunction. The system is shown as offline once these two cards areboth offline. Please note these two cards shall be in the same LAN.
