User Manual of NVR2XXX(-P4-P8) Series NVR212.1 Starting Up and Shutting Down the NVRPurpose:Proper startup and shutdown procedures are crucial to expanding the life of the NVR.Before you start:Check that the voltage of the extra power supply is the same with the NVR’s requirement, and the groundconnection is working properly.Starting up the NVR:Steps:1. Check the power supply is plugged into an electrical outlet. It is HIGHLY recommended that anUninterruptible Power Supply (UPS) be used in conjunction with the device.2. Turn on the power switch on the rear panel.3. After startup, the Power LED indicator turns on (supported by NVR22XX series NVR only). A splash screenwith the status of the HDD appears on the monitor. The row of icons at the bottom of the screen shows theHDD status. ‘X’ means that the HDD is not installed or cannot be detected.Shutting down the NVRSteps:1. Enter the Shutdown menu.Menu > ShutdownFigure 2. 1 Shutdown Menu2. Click the Shutdown button.3. Click the Yes button.4. Turn off the power switch on the rear panel when the attention pops up.Figure 2. 2 Shutdown Attention
