User Manual of NVR2XXX(-P4-P8) Series NVR655.8 Configuring HDD Group for RecordingPurpose:You can group the HDDs and save the record files in certain HDD group.Steps:1. Enter HDD setting interface.Menu>HDDFigure 5. 25 HDD General2. Select Advanced on the left bar.Figure 5. 26 Storage ModeCheck whether the storage mode of the HDD is Group. If not, set it to Group. For detailed information,please refer to Chapter 12.4 Managing HDD Group.3. Select General in the left bar.Click to enter editing interface.4. Configuring HDD group.1) Choose a group number for the HDD group.2) Click Apply and then in the pop-up message box, click Yes to save your settings.3) Click OK to back to the upper level menu.Repeat the above steps to configure more HDD groups.5. Choose the Channels which you want to save the record files in the HDD group.1) Select Advanced on the left bar.2) Choose Group number in the dropdown list of Record on HDD Group3) Check the channels you want to save in this group.4) Click Apply to save settings.Note: After having configured the HDD groups, you can configure the recording settings followingthe procedure provided in Chapter 5.2-5.7.
