1-9EnglishACCESSORIES Mounting plate1 Remote controller holder 1 AAA dry-cell batteries 2 Wireless remote controller $ Tō Tō1 Fixing screws for remotecontroller holder M3 × 16L2 Titanium apatitephotocatalytic air-purifyingfilter2 Drain socket 1 Drain plug 1 Installation manual Operation manual11*Only for heat pump models.CHOOSING AN INSTALLATION SITE• Before choosing the installation site, obtain user approval.Indoor UnitThe indoor unit should be sited in a place where:• The restrictions on installation specified in theindoor unit installation drawing are met.• Both air intake and exhaust have clear paths met.• The unit is not in the path of direct sunlight.• The unit is away from the sources of heat or steam.• There is no source of machine oil vapour (this mayshorten indoor unit life).• Cool air is circulated through out the room.• The unit is away from electronic ignition typeflourescent lamps (inverter or rapid start type). Asthese may shorten the remote controller range.• The unit is at least 1 metre away from anytelevision or radioset (unit may cause interferencewith the picture or sound).• Install at the recommended height (more than2.7m).• Do not install the units at or near doorway.• Do not operate any heating apparatus too closeto the air conditioner unit or use in room wheremineral oil, oil vapour or oil steam exist, this maycause plastic part to melt or deform as a result ofexcessive heat or chemical reaction.• When the unit is used in kitchen, keep flour awayfrom going into suction of the unit.• This unit is not suitable for factory used wherecutting oil, mist or iron powder exist or voltagefluctuates greatly.• Do not install the units at area like hot spring or oilrefinery plant where sulphide gas exists.• Ensure the color of wires of the outdoor unit andthe terminal markings are same to the indoorsrespectively.• IMPORTANT : DO NOT INSTALL OR USE THEAIR CONDITIONER UNIT IN A LAUNDRY ROOM.Do not use joined and twisted wires for incomingpower supply.The equipment is not intended for use in apotentially explosive atmosphere.Wireless Remote Controller• Do not expose the remote controller to directsunlight (this will hinder receiving signals from theindoor unit).• Turn on all the fluorescent lamps in the room,if any, and find the site where remote controllersignals are properly received by the indoor unit(within 7 metres).