Daikin BRC7E618: BRC7E619 Operation Manual

Also see for BRC7E618: BRC7E619: Operation manual

Contents

Daikin BRC7E618: BRC7E619 Operation Manual Manual pdf 6 page image

2 EnglishDo not place any burning appliance in theair current from the air conditioner, sincesuch appliance may suffer incompletecombustion.Never place nor use any inflammablesprays near the air conditioner, sincesuch sprays could cause a fire.The batteries must be removed fromthe appliance before it is scrappedand they are disposed of safely.2. NAMES AND FUNCTIONSOF THE OPERATING SEC-TION (Fig. 1, 2)1DISPLAY “ ”(SIGNAL TRANSMISSION)This lights up when a signal is beingtransmitted.2DISPLAY “ ” “ ” “ ” “ ”“ ” (OPERATION MODE)This display shows the current OPER-ATION MODE. For cooling only type,“ ” (Auto) and “ ” (Heating) arenot installed.3 DISPLAY “ ” (SET TEMPERATURE)This display shows the set temperature.4DISPLAY “ ”(PROGRAMMED TIME)This display shows PROGRAMMEDTIME of the system start or stop.5 DISPLAY “ ” (AIR FLOW FLAP)Refer to page 6.6 DISPLAY “ ” “ ” (FAN SPEED)The display shows the set fan speed.MH LChr. hr.7DISPLAY “ ”(INSPECTION/ TEST OPERATION)When the INSPECTION/TEST OPER-ATION BUTTON is pressed, the displayshows the system mode is in.8ON/OFF BUTTONPress the button and the system willstart. Press the button again and thesystem will stop.9FAN SPEED CONTROL BUTTONPress this button to select the fanspeed, HIGH or LOW, of your choice.10TEMPERATURE SETTING BUTTONUse this button for SETTING TEMPER-ATURE (Operates with the front coverof the remote controller closed.)11PROGRAMMING TIMER BUTTONUse this button for programming“START and/or STOP” time. (Operateswith the front cover of the remote con-troller opened.)12 TIMER MODE START/STOP BUTTONRefer to page 7.13 TIMER RESERVE/CANCEL BUTTONRefer to page 8.14 AIR FLOW DIRECTION ADJUST BUTTONRefer to page 6.15OPERATION MODE SELECTOR BUTTONPress this button to select OPERATIONMODE.16FILTER SIGN RESET BUTTONRefer to the section of MAINTENANCEin the operation manual attached to theindoor unit.17INSPECTION/TEST OPERATIONBUTTONThis button is used only by qualifiedservice persons for maintenancepurposes.18EMERGENCY OPERATION SWITCHThis switch is readily used if the remotecontroller does not work.TEST