|
Table of ContentsInstallation manual2(C)(F)TXA15~50A2V1B(W)(S)(T)Daikin room air conditioner3P482320-7H – 2018.02Table of Contents1 About the documentation 21.1 About this document.................................................................. 22 About the box 22.1 Indoor unit ................................................................................. 22.1.1 To remove the accessories from the indoor unit......... 23 About the unit 23.1 System layout............................................................................ 33.2 Operation range ........................................................................ 33.3 About the wireless adapter........................................................ 33.3.1 Precautions when using the wireless adapter............. 33.3.2 Basic parameters ........................................................ 34 Preparation 34.1 Preparing the installation site .................................................... 34.1.1 Installation site requirements of the indoor unit .......... 34.2 Preparing refrigerant piping....................................................... 44.2.1 Refrigerant piping requirements.................................. 44.2.2 Refrigerant piping insulation ....................................... 45 Installation 45.1 Opening the indoor unit ............................................................. 45.1.1 To open the indoor unit ............................................... 45.2 Installing the indoor unit ............................................................ 65.2.1 To install the mounting plate ....................................... 65.2.2 To drill a wall hole ....................................................... 75.2.3 To remove the pipe port cover .................................... 75.2.4 To provide drainage .................................................... 75.3 Connecting the refrigerant piping .............................................. 85.3.1 Guidelines when connecting the refrigerant piping ..... 85.3.2 To connect the refrigerant piping to the indoor unit .... 95.4 Connecting the electrical wiring................................................. 95.4.1 To connect the electrical wiring on the indoor unit...... 95.4.2 To connect optional accessories (wired userinterface, central user interface, etc.).......................... 105.5 Finishing the indoor unit installation .......................................... 105.5.1 To insulate the drain piping, refrigerant piping andinterconnection cable .................................................. 105.5.2 To pass the pipes through the wall hole ..................... 105.5.3 To fix the unit on the mounting plate........................... 106 Configuration 106.1 To set a different address.......................................................... 107 Commissioning 117.1 Checklist before commissioning................................................ 117.2 To perform a test run................................................................. 117.2.1 To perform a test run using the user interface ............ 118 Disposal 129 Technical data 139.1 Wiring diagram .......................................................................... 131 About the documentation1.1 About this documentINFORMATIONMake sure that the user has the printed documentation andask him/her to keep it for future reference.Target audienceAuthorised installersINFORMATIONThis appliance is intended to be used by expert or trainedusers in shops, in light industry, and on farms, or forcommercial and household use by lay persons.Documentation setThis document is part of a documentation set. The complete setconsists of:▪ General safety precautions:▪ Safety instructions that you MUST read before installing▪ Format: Paper (in the box of the indoor unit)▪ Indoor unit installation manual:▪ Installation instructions▪ Format: Paper (in the box of the indoor unit)▪ Installer reference guide:▪ Preparation of the installation, good practices, reference data,…▪ Format: Digital files on http://www.daikineurope.com/support-and-manuals/product-information/Latest revisions of the supplied documentation may be available onthe regional Daikin website or via your dealer.The original documentation is written in English. All other languagesare translations.Technical engineering data▪ A subset of the latest technical data is available on the regionalDaikin website (publicly accessible).▪ The full set of latest technical data is available on the Daikinextranet (authentication required).2 About the box2.1 Indoor unit2.1.1 To remove the accessories from theindoor unit1×2× 2× 2×1× 1× 1×1× 1× 1×edba c f g2×j kh ia Installation manualb Operation manualc General safety precautionsd Titanium apatite deodorizing filter and silver particle filter(Ag-ion filter)e Indoor unit fixing screw (M4×16L). Refer to "5.5.3 To fix theunit on the mounting plate" on page 10.f Dry battery AAA.LR03 (alkaline) for user interfaceg User interface holderh User interfacei Mounting platej Screw coverk Spare SSID sticker with release paper (attached to theunit)▪ Spare SSID sticker. Do NOT throw away the spare sticker. Keepit in a safe place in case it is needed in future (e.g. in case thefront grille was replaced attach it to the new front grille).3 About the unitWARNING: FLAMMABLE MATERIALThe refrigerant inside this unit is mildly flammable.
PreviousNext |