Daikin CTXM15N2V1B Installation Manual

Also see for CTXM15N2V1B: Operation manual Installer's reference guide

Contents

Daikin CTXM15N2V1B Installation Manual Manual pdf 9 page image

5 InstallationInstallation manual9CTXM15+ATXM20~50+FTXM20~71N2V1BDaikin room air conditioner3P482320-8K – 2018.092 Pass the drain hose and refrigerant pipes through the wall hole.5.5.3 To fix the unit on the mounting plate1 Set the indoor unit on the mounting plate hooks. Use the " "marks as a guide.2 Press the bottom frame of the unit with both hands to set it onthe bottom hooks of the mounting plate. Make sure that thewires do NOT get squeezed anywhere.Note: Take care that the interconnection cable does NOT getcaught in the indoor unit.3 Press the bottom edge of the indoor unit with both hands until itis firmly caught by the mounting plate hooks.4 Secure the indoor unit to the mounting plate using 2 indoor unitfixing screws M4×12L (accessory).5.6 Wireless LAN adapter5.6.1 About the wireless LAN adapterFor detailed specifications, installation instructions, setting methods,FAQ, declaration of conformity and the latest version of this manual,visit http://www.onlinecontroller.daikineurope.com.INFORMATION▪ Daikin Industries Czech Republic s.r.o. declares thatthe radio equipment type inside of this unit is incompliance with Directive 2014/53/EU.▪ This unit is considered as combined equipmentaccording to the definition of Directive 2014/53/EU.INFORMATIONInstall the wireless LAN adapter after finishing the indoorunit installation. Refer to "5.6.2 To install the wireless LANadapter" on page 9.Basic parametersWhat ValueFrequency range 2400 MHz~2483.5 MHzRadio protocol IEEE 802.11b/g/nRadio frequency channel 1~11Output power 0 dBm~18 dBmEffective radiated power 17 dBm (11b) / 13 dBm (11g) /12 dBm (11n)Power supply DC 14 V / 100 mA5.6.2 To install the wireless LAN adapterDANGER: RISK OF ELECTROCUTION▪ Turn off the power supply before installing the wirelessLAN adapter.▪ Do NOT handle the wireless LAN adapter with wethands.▪ Do NOT let the wireless LAN adapter get wet.▪ Do NOT disassemble, modify or repair.▪ Grip the connector when disconnecting the connectingcord.▪ Turn off the power supply if the wireless LAN adapterwas damaged.Symbol ExplanationThe protection of appliances marked with this symbolis ensured by double insulation and does not requirea safety connection to electrical earth (ground).To connect the wireless LAN adapter with the unit1 Remove the tape holding the connecting cord connector.Class 15~42 Class 50~71aaa Tape2 Cut the clip and remove the connector from the protectionsleeve.baa Protection sleeveb Clip3 Remove the upper case of the wireless LAN adapter.acba Upper caseb Printed circuit board of the wireless LAN adapterc Lower case4 Attach the connecting cord connector (white).