Daikin DCG Series Service Instructions Manual

Also see for DCC Series: Installation instructions Installation instructions Installation instructions Installation instructions Installation instructions

Contents

SYSTEM OPERATION26A. This appliance does not have a pilot. Itis equipped with an ignition device whichtry to light the burners by hand.automatically lights the burners. Do notthe appliance area for gas. Be sure tosmell next to the floor because some gasis heavier than air and will settle on thedo not use any telephone in yourDo not touch any electric switch;Do not try to light any appliance.WHAT TO DO IF YOU SMELL GASthe gas suppliers instructions.from a neighbor's phone. FollowImmediately call your supplier1. STOP! Read the safety information2. Set the thermostat to lowest setting.4. This appliance is equipped with anautomatic ignition system which3. Turn off all electric power to the6. Move the gas control switch or knob5. Remove control access panel.automatically lights the burners. Do nottry to light the burners by hand.B. BEFORE OPERATING smell aroundFOR YOUR SAFETY READ BEFORE OPERATINGSWITCH SHOWNIN "ON" POSITIONGAS CONTROLGAS CONTROLKNOB3. Remove control access panel.appliance if service is to be performed.2. Turn off all electric power to theor any other appliance.FOR YOUR SAFETY1. Set the thermostat to its lowest setting.TO TURN OFF GAS TO APPLIANCEother flammable vapors and liquids in the vicinity of thisto "OFF".above on this label.appliance.building.floor.instructions, thissetting.Do not store or use gasoline or4. Move the gas control switch or knobfollow the instructions "To Turn Off Gas5. Replace control access panel.To Appliance" and call your service12. If the appliance will not operate,to "OFF". Do not force.technician or gas supplier. in fuel combustionyou to substancesdeath or seriouswhich can causeillness and whichcause cancer, birthdefects or otherreproductive harm.are known to theThis product containsfiberglass insulation.State of California toproduct could exposeCalifornia to causecontains a chemicalFiberglass insulationcancer.B14933-239call a qualified service technician.will not operate, don't try to repair it,gas. If you then smell gas, STOP!8. Move the gas control switch or knobabove on this label. If you don't smellFollow "B" in the safety information7. Wait five (5) minutes to clear out anythe control system and any gas controlthe appliance and to replace any part ofa qualified service technician to inspecthas been under water. Immediately callD. Do not use this appliance if any parttools. If the gas control switch or knobcontrol switch or knob. Never useC. Use only your hand to move the gaswhich has been under water.If you do not follow these instructions exactly,a fire or explosion may result causing propertyIf you cannot reach your gas supplier,damage, personal injury or loss of life.Force or attempted repair may result in10. Turn on all electric power to the11. Set the thermostat to the desired9. Replace control access panel.a fire or explosion.to "ON".OPERATING INSTRUCTIONSgas, go to the next step.appliance.call the fire department.consult a qualifiedor the gas supplier.For outdoorinstallation only.WARNING:and maintained inmanufacturer'sinstalled, operatedaccordance with theof local codes, followcodes. In the absenceinstructions and localThis furnace must beCode, ANSI Z223.1.the National Fuel GasIf notWARNING:cause injury orRefer to the user'sinformation manualprovided with thisproperty damage.maintenance canalteration, service orImproperGASCONTROLSWITCHSHOWNIN "ON"POSITIONDCG***XXX**XXX