SiBE04-624 OthersOthers 2991.2 Field Setting1.2.1 Humidifying Hose LengthSetting the humidifying hose length.z Set the humidifying hose length to ensure humidifying capacity. Use the remote controllerto set the humidifying hose length. When doing this, power on the unit as communicationis established between the unit and the remote controller.(The humidifying hose length includes the rear of the indoor unit.)(1) Hold “CLOCK button” for more than 5 seconds.(To cancel, do not operate the button for 10 seconds. The display will return to normal.)(2) Press “SELECT . button”.Select “ ”(3) Press “CLOCK button” to activate the hose length setting mode.(Be sure to direct the remote controller toward the main unit while operating it.)The display will show the currently set hose length.(Default is no setting.)(4) Press “SELECT . button” to set the humidifying hose length.Pressing “SELECT . button” changes the hose length.You may set the hose length to 5 levels, ~3M, 3.1~4M, 4.1~6M, 6.1~8M, 8.1~10M.(5) Press “CLOCK button” after selecting the hose length.(Direct the remote controller toward the main unit while operating it.)(6) Hold “CLOCK button” for more than 5 seconds.The humidifying hose length setting is complete.If you set the wrong humidifying hose length, cancel the setting displaying“ ” with the step 4) operation and reset it.When the unit cannot be powered on.z When setting the humidifying hose length without powering on the unit, the display shows“ ” with the step 5) operation shown above but the remote controllerremembers the set hose length.(When the customer uses the unit, the humidifying hose length information is sent to theindoor unit to be set.)(R5905)“CLOCK button”Matrix display“SELECT button”
