Installation Manual SiBE04-62484 System Configuration3Indoor Unit Installation Drawings2. Removing and installing indoor unit.• Installation method1) Using the marks (3 locations) on top of theindoor unit, attach the mounting plate hooksonto the indoor unit.2) Attach the tabs on the bottom frame onto themounting plate. If the tabs are not hooked ontothe plate, remove the front grille to hook them.(Check to see if the tabs are hooked securely.)• Removal methodPush up the mark part on the bottom of the frontgrille, discharge the tabs, and then remove the unitwhile lifting it up.TabBottomframeMark(rear side)A MountingplateTo remove the unit, push up the bottom of the bottomframe with your fingers to free tabs.(Mark parts (2 locations) on the bottom of the front grille.)A MountingplateAAHRemotecontroller holderScrews(Field supply: M3 × 20L)Air supplyfilterDWrap the insulationpipe with the finishingtape from bottom to top.Install thehose with adownwardslope.Do not install the trap tothe humidifying hose asmuch as possible.If it is difficult to lay the humidifyinghose, cut it, lay it, and connect itusing the joint or elbow includedwith the outdoor unit.Cut thermal insulation pipeto an appropriate length andwrap it with tape, makingsure that no gap is left in theinsulation pipe’s cut line.30mm or morefrom ceiling50mm or morefrom walls(on both sides)Screws(Field supply: M4 × 25L)A Mounting plateThe mounting plateshould be installed on awall which can support theweight of the indoor unit.Use whenopening thefront panel andsecuring.Supporting plateSupporting plateHow to open the service lidFront panelAir filter2)1)The service lid isremovable.Opening the lid1) Remove the screwson the service lid.2) Hold the knobs on theservice lid and pullforward.HumidifyinghoseBefore screwing theremote controllerholder to the wall,make sure that controlsignals are properlyreceived by indoor unit.C Titanium apatitephotocatalyticair-purifying filterB Deodorizing filterfor streamerHookG Wirelessremote controllerSet thebatteries.JThe securing tape is applied.Be sure to remove it beforeinstallation.A
