Daikin FT10LV1L Technical Manual

Contents

Daikin FT10LV1L Technical Manual Manual pdf 19 page image

18TM-FT-0415-B5. InstallationsInstallation GuidelineSafety PrecautionsWARNINGCAUTIONPlease take note of the following important points when installing.If gas leaks and accumulates around the unit, it may cause fire ignition.Ensure that drainage piping is connected properly.If the drainage piping is not connected properly, it may cause water leakage which willdampen the furniture.Do not overcharge the unit.This unit is factory pre-charged. Overcharge will cause over-current or damage to the compressor.Ensure that the unit’s panel is closed after service or installation.Unsecured panels will cause the unit to operate noisily.Sharp edges and coil surfaces are potential locations which may cause injury hazards.Avoid from being in contact with these places.Before turning off the power supply, set the remote controller’s ON/OFF switch to the “OFF” positionto prevent the nuisance tripping of the unit. If this is not done, the unit’s fans will start turningautomatically when power resumes, posing a hazard to service personnel or the user.Do not operate any heating apparatus too close to the air conditioner unit. This may cause the plasticpanel to melt or deform as a result of the excessive heat.Ensure the color of wires of the outdoor unit and the terminal markings are same to the indoors respectively.IMPORTANT : DO NOT INSTALL OR USE THE AIR CONDITIONER UNIT IN A LAUNDRY ROOM.Do not use joined and twisted wires for incoming power supply.Do not install the unit where leakage of flammable gas may occur.••••••••••NOTICE• Installation and maintenance should be performed by qualified persons who are familiar with local codeand regulation, and experienced with this type of appliance.• All field wiring must be installed in accordance with the national wiring regulation.• Ensure that the rated voltage of the unit corresponds to that of the name plate before commencing wiringwork according to the wiring diagram.• The unit must be GROUNDED to prevent possible hazard due to insulation failure.• All electrical wiring must not touch the refrigerant piping or any moving parts of the fan motors.• Confirm that the unit has been switched OFF before installing or servicing the unit.• Disconnect from the main power supply before servicing the air conditioner unit.• DO NOT pull out the power cord when the power is ON. This may cause serious electrical shocks whichmay result in fire hazards.• Keep the indoor and outdoor units, power cable and transmission wiring, at least 1m from TVs and radios,to prevent distorted pictures and static. {Depending on the type and source of the electrical waves, staticmay be heard even when more than 1m away}.Disposal requirementsYour air conditioning product is marked with this symbol. This means that electrical and electronicproducts shall not be mixed with unsorted household waste.Do not try to dismantle the system yourself: the dismantling of the air conditioning system, treatmentof the refrigerant, of oil and of other parts must be done by a qualified installer in accordance withrelevant local and national legislation. Air conditioners must be treated at a specialized treatmentfacility for re-use, recycling and recovery. By ensuring this product is disposed of correctly, you willhelp to prevent potential negative consequences for the environment and human health. Pleasecontact the installer or local authority for more information.Batteries must be removed from the remote controller and disposed of separately in accordance withrelevant local and national legislation.