Daikin FT10LV1L Technical Manual

Contents

Daikin FT10LV1L Technical Manual Manual pdf 21 page image

20TM-FT-0415-BAir flow(Indoor)min. 75(Space for performance)Required spaceAll dimensions are in mmmin. 50(Space formaintenance)min. 50(Space formaintenance)Right-Side, Right-Back or Right-Bottom PipingRight-back pipingBind coolant pipeand drain hosetogether withinsulating tape.Right-bottompipingRemove pipe port cover herefor right-bottom pipingRight-sidepipingRemove pipe port coverhere for right-side pipingRemove pipe port cover herefor left-bottom pipingRemove pipeport cover herefor left-sidepipingLeft-backpipingLeft-bottom pipingLeft-Side, Left-Back or Left-Bottom PipingLeft-sidepipingInstallation Of The Indoor UnitThe indoor unit must be installed in such a way so asto prevent short circuit of the cool discharged air withthe hot return air. Please follow the installationclearance shown in the figure. Do not place the indoorunit where there could be direct sunlight shining on it.Also, this location must be suitable for piping anddrainage, and be away from doors or windows.The refrigerant piping can be routed to the unit in a number of ways (left or right from the back of the unit), byusing the cut-out holes on the casing of the unit (see figure). Bend the pipes carefully to the required positionin order to align it with the holes. For the side and bottom out, hold the bottom of the piping and then positionit to the required direction (see figure). The condensation drain hose can be taped to the pipes.Mounting Installation PlateMounting plateMounting platefixing screwFT10/15LV1L/M & FT10/15MV1I/JFTN10/15PV1L/M & FTN10/15MV1I9/J9Mounting plateMounting platefixing screwFT20/25LV1L/M & FT20/25MV1I/JFTN20/25PV1L/M & FTN20/25MV1I9/J9FT311V1L/M & FTN311V1L/MInstallation plateMarking-offlineThreadEnsure that the wall is strong enough to withstand theweight of the unit. Otherwise, it is necessary to reinforcethe wall with plates, beams or pillars. Use the levelgauge for horizontal mounting, fix it with 5 suitablescrews for FT10/15LV1L/M, FTN10/15PV1L/M &FT10/15MV1I/J, FTN10/15MV1I9/J9 and 7 suitablescrews for FT20/25LV1L/M, FTN20/25PV1L/M &FT20/25MV1I/J, FTN20/25MV1I9/J9 and 4 suitablescrews for FT311V1L/M & FTN311V1L/M. In case therear piping draws out, drill a hole 65mm in diameter witha cone drill, slightly lower on the outside wall (see figure).