Daikin FT20FV1M Installation Manual

Contents

Daikin FT20FV1M Installation Manual Manual pdf 6 page image

4INSTALLATION OF THE INDOOR UNITThe indoor unit must be installed in such a way so as to prevent short circuit ofthe cool discharged air with the hot return air. Please follow the installationclearance shown in the figure. Do not place the indoor unit where there could bedirect sunlight shining on it. Also, this location must be suitable for piping anddrainage, and be away from doors or windows.Maintenance &Servicing SpaceAir FlowDirectionHigherThanEye Level50.0 mm 50.0 mmRouting Of PipingRemove the screw holding the front panel.The refrigerant piping can be routed to the unit in a number ofways (left or right from the back of the unit), by using thecut-out holes on the casing of the unit (see figure). Bend thepipes carefully to the required position in order to align it withthe holes. For the right hand and rear side out, hold the bottomof the piping and then position it to the required direction (seefigure). The condensation drain hose can be taped to the pipes.12 345Piping RoutingRight & Rear Side RoutingUnit PipingDrain Hose Fix With Vinyl TapeMount The Unit Onto The Installation PlateHook the indoor unit onto the upper portion of theinstallation plate (Engage the two hooks at the rear top of theindoor unit with the upper edge of the installation plate). Ensurethat the hooks are properly seated on the installation plate bymoving it to the left and right.Water Drainage PipingThe indoor drain pipe must be in a downward gradient for smoothdrainage. Avoid situations that are likely to cause water to leak.CorrectEndDippedIntoWaterWaterLeakingWaterLeaking WaterLeakingWrong Wrong WrongDrainWater Drainage1. Hook the unit onto the installation plate.Mounting Installation PlateEnsure that the wall is strong enough to withstand the weight of the unit. Otherwise, it is necessary to reinforce the wall withplates, beams or pillars.Use the level gauge for horizontal mounting, and fix it with 4 suitable screws.In case the rear piping draws out, drill a hole 65mm in diameter with a cone drill, slightly lower on the outside wall (see figure).Screw Position In The Wall72.0Centre LineØ 65.0 mm Hole In The WallScrew Position In The WallØ 65.0 mm Hole In The WallInside Outside1/50 InclinationHole With Cone DrillIndoor Side Outdoor SideWaterRetention