9DRY • COOL • FANOperationThe air conditioner operates with the settings ofyour choice. From the next time on, the airconditioner will operate with the same settings.1 Press MODE and select a mode. Each pressing of the button advancesthe mode setting in sequence.2 Press ON/OFF. Then OPERATIONlamp lights up. To stop:PressON/OFFonce again.Then OPERATION lamp goes off. To change the temperature setting: To change the air flow rate setting:Press FAN . At smaller air flow rates, cooling orheating effect is also smaller.DisplayDRY or FAN modeThe temperaturesetting is notvariable.COOL modePressto raise / lower the temperature.Set to thetemperature you like.TEMPDRY modeThe air flow ratesetting is notvariable.COOL or FAN modeFive levels of air flow rate settingfrom “ ” to “ ” plus “ ” areavailable.DisplayAdjusting the AirFlow DirectionATTENTION Be careful when adjusting the louvre. Insidethe air outlet, a fan is rotating at a high speed.ATTENTION Always use a remote controller to adjustthe flap angle. If you attempt to move itforcibly with hand when it is swinging, themechanism may be broken.You can adjust the air flow direction to increaseyour comfort.Adjusting the horizontalblade (flap)Press SWING . Every time the button is pressed, “ ”appears or disappears........ The flap automaticallyswings up and down........ To stop the flap at an angleyou like, press SWING .Notes on flap angles When SWING is selected, theflap swinging range dependson the operation mode. (Seethe figure.) The real flap angles are differfrom the display of remotecontroller.Adjusting the vertical blade(louvre)Hold the knob and move the louvre.(You will find a knob on the left-side and theright-side blades.)DRY • COOLFAN