Daikin FT50GAVE Operation Manual

Contents

11Timer OperationTimer functions are useful for automaticallyswitching the air conditioner on or off at night orin the morning. You can also use OFF TIMERand ON TIMER in combination.OFF TIMER operation Check that the clock is correct.If not, set the clock to the present time. (Seepage 8.)1 Press OFF while the air conditioneris operating.AM is displayed.blinks.* Previous time settingappears on display.2 PressTIMERuntil the time settingreaches the point you like. Every pressing of either button increasesor decreases the time setting by 10minutes. Holding down either buttonchanges the setting rapidly.3 Press OFF once again.Then the TIMER lamplights up. To cancel the timer:Press CANCEL .Then the TIMER lamp goes off.Notes on OFF TIMER NIGHT SET MODEWhen the OFF TIMER is set, the airconditioner automatically adjusts thetemperature setting (0.5°C up in COOL) toprevent excessive cooling for your pleasantsleep.AMDisplayAMDisplayON TIMER operation Check that the clock is correct. If not, set theclock to the present time. (See page 8.)1 Press ON while the air conditioner isnot operating.AM is displayed.blinks.* Previous time settingappears on display.2 Press TIMERuntil the time settingreaches the point you like. Every pressing of either button increases ordecreases the time setting by 10 minutes. Holdingdown either button changes the setting rapidly.3 Press ON once again.Then the TIMER lamp lights up.Combining ON TIMER and OFF TIMER A sample setting for combining the two timers is shown below.Notes on ON,OFF TIMER When TIMER is set, the present time is not displayed. Once you set ON,OFF TIMER, the time settingis kept in the memory. (The memory is canceledwhen remote controller batteries are replaced.) When operating the unit via the ON/OFF Timer, theactual length of operation may vary from the timeentered by the user.(Maximum approx. 10 minutes.)AMDisplayAMDisplayATTENTION In the following cases, set the timer again. After a breaker has turned OFF. After a power failure. After replacing batteries in the remote controller.AM AMDisplay(Example)Present time: 11:00 PM(The unit operating)OFF TIMER at 0:00 a.m. CombinedON TIMER at 7:00 a.m. )