Daikin FTX09NMVJU Operation Manual

Also see for FTX09NMVJU: Service manual Engineering data Installation manual Installation manual Service manual

Daikin FTX09NMVJU Operation Manual Manual pdf 11 page image

10EnglishEnglishRead Before OperationPreparation Before OperationTo insert the batteries1. Remove the back cover by sliding and thenslightly lifting it�2. Insert 2 dry batteries AAA�LR03 (alkaline)�3. Replace the back cover�To fix the remote controller holder to a wall1. Choose a place where the signals reach the unit�2. Attach the holder to a wall, a pillar, or similarlocation with the screws supplied with the holder�3. Hang the remote controller on the remotecontroller holder�Fahrenheit/Celsius display switchPress and (TIMER button)simultaneously for about 5 seconds�• The temperature will be displayed in Celsius when it is presently displayed inFahrenheit, and vice versa.• The switch operation is only possible when the temperature is being displayed.Turn on the circuit breaker• After the power is turned on, the flap of the indoor unit opens and closes once to set thereference position.Position andcorrectly!2 31Remotecontroller holderRemote controllerScrewsNOTENotes on batteries• When replacing the batteries, use batteries of the same type, and replace both old batteries together.• The batteries will last for about 1 year. However, if the remote controller display begins to fade and the possible transmission range becomesshorter within a year, replace both batteries with new, size AAA.LR03 (alkaline) batteries.• The batteries supplied with the remote controller are for initial operation. The batteries may run out in less than 1 year.Note on remote controller• Do not drop the remote controller. Do not get it wet.Fahrenheit/Celsius display change function of remote controller• The set temperature may increase when the display is changed to Celsius from Fahrenheit, because a fraction of 0.5°C is rounded up.• Example: A set temperature of 65°F (equivalent to 18.5°C) will be converted into 19°C.When the display is changed to Fahrenheit again, the set temperature will be converted into 66°F (equivalent to 19°C) instead of the originalset temperature (65°F) but a set temperature of 66°F (equivalent to 19°C) will be converted into 19°C with no temperature change.• A reception sound will go off for the transmission of set temperature to the indoor unit at the time of setting the Fahrenheit/Celsius display change function.