Daikin FTX09NMVJU Service Manual

Also see for FTX09NMVJU: Service manual Engineering data Installation manual Installation manual Service manual

Contents

Daikin FTX09NMVJU Service Manual Manual pdf 130 page image

Field Settings SiUS091601E119 Trial Operation and Field Settings4.2 When 2 Units are Installed in 1 RoomOutline When 2 indoor units are installed in 1 room, 1 of the 2 indoor units and the corresponding wirelessremote controller can be set for different addresses.FTX Series (1) Remove the battery cover of the remote controller.(2) Cut the address jumper.(3) Press the center of TEMP button and OFF button on the remote controller at the same time.(4) Select A (address setting) with TEMP or TEMP button.(5) Press FAN button to enter the address setting mode.→ The indoor unit operation lamp blinks for 1 minute.(6) Press indoor unit ON/OFF button while the operation lamp is blinking.(7) Press FAN button on the remote controller for 5 seconds to return to the normal mode.Caution Replace the remote controller if you accidentally cut a wrong jumper.Jumpers are necessary for electronic circuit. Improper operation may occur if you cut any of them.AddressEXISTJumperCUT12(R21071)Jumper(R21822)(R21072)ON/OFFOPERATION lampIndoor unitON/OFF button