22ON TIMER Operation■ To use ON TIMER operation• Check that the clock is correct.If not, set the clock to the present time. Page 101. Press .• “ ” is displayed on the LCD.• “ ” blinks.• “ ” and day of the week disappear from the LCD.2. Press until the time setting reaches thepoint you like.• Each pressing of either button increases or decreases the time setting by 10 minutes.Holding down either button changes the setting rapidly.3. Press again.• “ ” and setting time are displayed on the LCD.• The TIMER lamp lights yellow. Page 5Display■ To cancel ON TIMER operationPress .• “ ” and setting time disappear from the LCD.• “ ” and day of the week are displayed on the LCD.• The TIMER lamp goes off.■ To combine ON TIMER and OFF TIMER• A sample setting for combining the 2 timers is shown below.(Example)Present time: 23:00 (The unit operating)OFF TIMER at 0:00ON TIMER at 14:00 CombinedNOTE■ In the following cases, set the timer again.• After a breaker has turned off.• After a power failure.• After replacing batteries in the remote controller.