Daikin FTXN15KVJU Installation Manual

Also see for FTXN15KVJU: Service manual Operation manual Service manual Operation manual

Contents

Daikin FTXN15KVJU Installation Manual Manual pdf 9 page image

8 ■EnglishIndoor Unit Installation1. Installing the mounting plate• The mounting plate should be installed on a wall which can support the weight of the indoor unit.1) Temporarily secure the mounting plate to the wall, make sure that the plate is completely level, and mark the boringpoints on the wall.2) Secure the mounting plate to the wall with screws.Recommended mounting plate retention spots and dimensions2. Boring a wall hole and installing wall embedded pipe• For walls containing metal frame or metal board, be sure to use a wallembedded pipe and wall cover in the feed-through hole to prevent possibleheat, electrical shock, or fire.• Be sure to caulk the gaps around the pipes with caulking material to preventwater leakage.1) Bore a feed-through hole of 3-1/8 inch (80mm) in the wall so it has a downslope toward the outside.2) Insert a wall pipe into the hole.3) Insert a wall cover into wall pipe.4) After completing refrigerant piping, wiring, and drain piping, caulk pipe holegap with putty.3. Inter-unit wiring1) Open the front panel, then open the service lid.2) Pass the inter-unit wire from the outdoor unit through the feed-through wall hole and then through the back of the indoor unit. Pullthem through the front side. Bend the ends of tie wires upward foreasier work in advance. (If the inter-unit wire ends are to be strippedfirst, bundle wire ends with adhesive tape.)3) Press the bottom frame of the indoor unit with both hands to set it onthe mounting plate hooks. Make sure the wires do not catch on theedge of the indoor unit.* The removed pipe port cover can bekept in the mounting plate pocket. Removed pipeport coverA Mountingplateunit : inch (mm)4-15/16(125)2-3/8(60) 3-1/8(83)19-13/16(503.5)1-3/4(44.5)11-7/16(290)2-1/16 (52)41-5/16(1050)3-15/16(99.5)2-1/16(52) 3-9/16(90)3-15/16(100)3-15/16(100)Through-the-wallhole φ3-1/8 (φ80)Drain hose positionRecommended mounting - plate retentionspots (9 spots in all)(Bolt size : 3/8 (M10)) (Bolt size : 3/8 (M10))Place a leveler on raised tab.Use tapemeasureas shown.Position theend of tapemeasure at ∇Gas pipe endLiquid pipe endφ3-1/8(φ80) φ3-1/8(φ80)Inside OutsideCaulkingWall embedded pipe(field supply)Wall hole cover(field supply)Wall embedded pipe(field supply)φ3-1/8”(φ80mm)When stripping theends of inter-unit wire inadvance, bind right endsof wires with insulating tape.Hang indoor unit’s hook here.Inter-unit wireMounting plateA