Assembling the Fuse DisconnectComponents1. Remove (2) screws securing the base plate to thebox, and disconnect the base from the cover.2. Locate receptacle and plastic bag containing screwsand wire grommet. Assemble the receptacle andgrommet for a right hand or left hand unit installation(Figure 2).Figure 2. Location of Disconnect Assembly3. Knock out top holes for fuse holders. Locate fusesand fuse holders from kit.4. Remove fuse holder top, insert fuse, and reassembletop to fuse holder. Install fuse holders into box using(4) screws.Installation & Maintenance DataConsole Water Source Heat Pumps – Model MHC & MHWFuse/ Non-Fuse Disconnect (High-Sill Units Only)Group: WSHPPart Number: 669286601Date: October 2013IM 975Procedure – Field Installed Accessory1. Remove the fuse disconnect components from theshipping carton and check that all parts are includedin the kit. Compare the parts to the parts list enclosedwith the kit.Figure 1. Fused Disconnect AssemblyWARNINGInstallation and maintenance are to be performed byqualified personnel who are familiar with local codes andregulations, and experienced with this type of equipment.Disconnect all electrical power before servicing unit.Electrical shock will cause severe injury or death.DANGERCAUTIONSharp edges can cause personal injury. Avoid contactwith them.©2013 Daikin Applied • www.DaikinAP.com • 800.432.1342