Daikin RXF60B2V1B Installer's Reference Manual

Also see for ARXM50N2V1B: Installation manual

Daikin RXF60B2V1B Installer's Reference Manual Manual pdf 12 page image

6 InstallationInstaller reference guide12RXF50+60B2_RXF71A2_RXP50~71L2_(A)RXM42~71N2_RXJ50N2_RXA42+50B2R32 split series4P513661-6B – 2018.05Use a vibration-proof rubber (field supply) in cases where vibrationsmay be transmitted to the building.Fix the unit securely by means of foundation bolts in accordancewith the foundation drawing.Prepare 4 sets of M8 or M10 anchor bolts, nuts and washers (fieldsupply).20 mm353600240(mm)240>300In any case, provide at least 300 mm of free space below the unit.Additionally, make sure the unit is positioned at least 100 mm abovethe maximum expected level of snow. In this case, it isrecommended to construct a pedestal.6.3.4 To install the outdoor unit4× M8/M106.3.5 To provide drainage▪ Make sure that condensation water can be evacuated properly.▪ Install the unit on a base to make sure that there is properdrainage in order to avoid ice accumulation.▪ Prepare a water drainage channel around the foundation to drainwaste water away from the unit.▪ Avoid drain water flowing over the footpath, so that it does NOTbecome slippery in case of ambient freezing temperatures.▪ If you install the unit on a frame, install a waterproof plate within150 mm of the bottom side of the unit in order to prevent waterfrom getting into the unit and to avoid drain water dripping (see thefollowing figure).NOTICEIf the unit is installed in a cold climate, take adequatemeasures so that the evacuated condensate CANNOTfreeze.INFORMATIONFor information on the available options, contact yourdealer.NOTICEProvide at least 300 mm of free space below the unit.Additionally, make sure the unit is positioned at least100 mm above the expected level of snow.1 Use a drain plug for drainage.2 Use a Ø16 mm hose (field supply).bcdaa Drain portb Bottom framec Drain plugd Hose (field supply)To close the drain holes and attach the drainsocketNOTICEIn cold areas, do NOT use a drain socket, hose and caps(1, 2) with the outdoor unit. Take adequate measures sothat the evacuated condensate CANNOT freeze.1 Install drain caps 1 and 2 (accessory). Make sure the edges ofthe drain caps close off the holes completely.a ba Bottom frameb Drain cap2 Install the drain socket.a cb b baaa Drain hole. Install a drain cap (2).b Drain hole. Install a drain cap (1).c Drain hole for drain socket6.3.6 To prevent the outdoor unit from fallingoverIn case the unit is installed in places where strong wind can tilt theunit, take following measure: