• Air Pump• Generator Bushings• Drive Belts• Drive Belt Idler/Tensioner Pulley• Wheel Bearings• Rubber Bushings• Starter Bearings/Bushings• Suspension Strut Bearings• Throttle Control Cable• Throttle Linkage• Water Pump BearingsFLUID CAPACITIESFuel Tank..............................................68 L (18 gal.)Engine Oil3.3L ...........................................................4.7L (5 qts.)3.5L ........................................................5.2L (5.5 qts.)Cooling System3.3L ................................................10.74L (10.17 qts.)3.5L.................................................12.46L (11.80 qts.)Includes heater and coolant pressure bottleTransmission.......................................9.4L (9.9 qts.)Differential..............................................0.95L (1 qt)MAINTENANCE SCHEDULESINTRODUCTIONChrysler Corporation has compiled recommendedlubrication and maintenance schedules and proce-dures to help reduce premature wear or failure over abroad range of operating conditions. When selectingthe proper maintenance schedule, the climate andoperating conditions must be considered. A vehiclesubjected to severe usage requires service more fre-quently than a vehicle used for general transporta-tion.GENERAL SERVICE MAINTENANCEAT EACH STOP FOR GASOLINE CHECK• Engine oil level and add as required.• Windshield washer solvent and add if required.ONCE A MONTH• Check tire pressure and look for unusual wear ordamage.• Inspect battery and clean and tighten terminals asrequired.• Check fluid levels of coolant pressure bottle, brakemaster cylinder, power steering and transmission.Add fluid as needed.• Check all lights and all other electrical items forcorrect operation.7,500 MILES (12 000 KM) OR AT 6 MONTHS• Check engine coolant level, hoses and clamps.• Change engine oil.• If it has been 12 months since your last oil filterchange, replace the filter at this mileage.• Rotate tires.• Check exhaust system.15,000 MILES (24 000 KM) OR AT 12 MONTHS• Check engine coolant level, hoses and clamps.• Change engine oil.• Replace engine oil filter.• Adjust the belt tension of non-automatic tensioningdrive belts.• Rotate tires.• Check exhaust system.22,500 MILES (36 000 KM) OR AT 18 MONTHS• Check engine coolant level, hoses and clamps.• Change engine oil.• If it has been 12 months since your last oil filterchange, replace the filter at this mileage.• Rotate tires.• Check exhaust system.30,000 MILES (48 000 KM) OR AT 24 MONTHS• Replace air cleaner filter.• Replace spark plugs.• Check engine coolant level, hoses and clamps.• Change engine oil.• Replace engine oil filter.• Replace the PCV filter (if equipped).• Adjust the belt tension of non-automatic tensioningdrive belts.• Rotate tires.• Check exhaust system.37,500 MILES (60 000 KM) OR AT 30 MONTHS• Check engine coolant level, hoses and clamps.• Change engine oil.• If it has been 12 months since your last oil filterchange, replace the filter at this mileage.• Rotate tires.• Check exhaust system.0 - 2 LUBRICATION AND MAINTENANCE