Daiwa D-17 Installation Manual
                 | |
42. GENERAL INFORMATIONNational Standards, European Standards, local regulations, constructionregulations, fire protection and safety regulations must be observed.During the installation, one must contact a person who is authorized for thechimney. The authorized person shall check the shape of the chimney connectionof the product in the prescribed directions. In addition, the product installationand installation connection must be made by an authorized person. Beforeinstalling the stove, the lifting capacity of the installation ground should bechecked whether it is resistant for the stove. In case of insufficient load resistanceor low lifting capacity, suitable precautions must be taken (eg put a stove liftingplate).3. SAFETYTHE VENTILATION CONDITIONS WHERE THE PRODUCT WILL BE INSTALLEDAND THE PROTECTION AGAINST FREEZING MUST BE TAKEN INTOCONSIDERATION.All the required standard examinations are tested for the product. The predictedparameters associated with combustion efficiency and exhaust gas emissions areobserved. The stove type described in this manual has been tested according to theBA 1, DIN 1881 EN13240 standards, by an approved agency.Combustion chamber cover should be opened only to load the fuel. To avoidhazards, the combustion chamber must be closed. For the efficient operation ofthe stove, there must be minimum of fresh air flow in the room where it isinstalled.CAUTION! The stove can operate in conjunction with the existing multipleflue systems. This should not be an aspirator, ventilator etc.The combustion of combustible materials causes heat energy to heat the stovesurfaces (doors, door handles, flame monitor cover, side walls, front wall). Theseparts should not be touched without heat-protective gloves.CAUTION! Since the stove top surface might be hot, please do not putcombustible materials on it. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine