62 • Operational Reference Calibir 640 GigE IR Camera User's ManualI2C Slave Address i2cSlaveAddress Specifies the I2C slave address of the device. Thisfeature is only for configuration of the Calibir 640 Coreversion.GuruDFNCDevice Acquisition Type deviceAcquisitionType Displays the Device Acquisition Type of the product. InvisibleDFNCSensor Sensor The device gets its data directly from a sensor.Device TL Type DeviceTLType Transport Layer type of the device. InvisibleGigE Vision GigEVision GigE Vision Transport LayerDevice TL Version Major DeviceTLVersionMajor Major version of the device’s Transport Layer. InvisibleDevice TL Version Minor DeviceTLVersionMinor Minor version of the device’s Transport Layer. InvisibleuserSetError Error in user setNoError No ErrorLoadGenericError Unknown errorLoadBusyError The camera is busy and cannot perform the actionLoadMemoryError Not enough memory to load setLoadFileError Internal file I/O errorLoadInvalidSetError At least one register could not be restored properlyLoadResourceManagerError An internal error happened related to the resourcemanagerSaveGenericError Unknown errorSaveBusyError The camera is busy and cannot perform the actionSaveMemoryError Camera ran out of memory while saving setSaveFileError Internal file I/O errorSaveInvalidSetError An invalid user set was requestedSaveResourceManagerError An internal error happened related to the resourcemanagerDFNC Major Rev deviceDFNCVersionMajor Major revision of Dalsa Feature Naming Conventionwhich was used to create the device’s XML.DFNC Minor Rev deviceDFNCVersionMinor Minor revision of Dalsa Feature Naming Conventionwhich was used to create the device’s XML.SFNC Major Rev DeviceSFNCVersionMajor Major Version of the Genicam Standard FeaturesNaming Convention which was used to create thedevice's XML.InvisibleSFNC Minor Rev DeviceSFNCVersionMinor Minor Version of the Genicam Standard FeaturesNaming Convention which was used to create thedevice's XML.InvisibleSFNC SubMinor Rev DeviceSFNCVersionSubMinor SubMinor Version of the Genicam Standard FeaturesNaming Convention which was used to create thedevice's XML.InvisiblePower-up Configuration DialogCamExpert provides a dialog box which combines the features to select the camera power-up stateand for the user to save or load a Calibir GigE camera state.
