X64 Xcelera-HS PX8 User's Manual X64 Xcelera-HS PX8 Reference • 51trash buffer, which is defined as the last buffer in the list; otherwise it will occur in the nextbuffer. After a transfer to the trash is done, the transfer device will check the next buffer inthe list, if its state is empty, it will transfer to this buffer otherwise it will skip it, andtransfer again to the trash buffer.• CORXFER_VAL_CYCLE_MODE_ASYNCHRONOUSThe transfer device cycles through all buffers in the list without concern about the bufferstate.Output LUT AvailabilityThe following table defines the supported output LUT (look up tables) for the X64 Xcelera-HS PX8.Note that unsupported modes are not listed.Number of Bits Output Pixel Format LUT Format Notes88MONO 8MONO 168-in, 8-out8-in, 8-out 8 bits in 8 LSBs of 16-bit10 MONO 8 10-in, 8-out10 MONO 16 10-in, 16-out12 MONO 8 12-in, 8-out 8 MSB12 MONO 16 12-in, 16-outTable 9: Output LUT AvailabilityX64 Xcelera-HS PX8 Supported ParametersThe tables below describe the Sapera capabilities supported by the X64 Xcelera-HS PX8 (i.e.default firmware is loaded). Unless specified, each capability applies to both boards or all modeconfigurations and all acquisition modes.The information here is subject to change. Capabilities should be verified by the applicationbecause new board driver releases may change product specifications.Specifically the X64 Xcelera-HS PX8 family is described in Sapera as:• Board Server: Xcelera-HS_PX8_1• Acquisition Module: dependent on firmware usedCamera Related CapabilitiesCapability ValuesCORACQ_CAP_CONNECTOR_TYPE CORACQ_VAL_CONNECTOR_TYPE_CX4 (0x8)CORACQ_CAP_CX4_CONFIGURATION 0x6Table 10: Camera Related Capabilities
