Xtium-CL PX4 User's Manual Technical Specifications • 61Controls Compliant with Teledyne DALSA Trigger-to-Image Reliability frameworkComprehensive event notificationsTiming control logic for camera triggers and strobe signalsExternal trigger latency less than 100 nsecSupports multi-board / multi-camera synchronizationQuadrature (phase A & B) shaft encoder inputs for external websynchronization: RS-422 input maximum frequency is 5 MHz4 opto-coupled general inputs (RS-422/TTL/12V/24V).Can be used as opto-coupled external trigger inputs programmable asactive high or low (edge or level trigger).4 TTL general outputs. Can be used as Strobe outputs.I/O available on a DH60-27P connector (J1)ProcessingDependant on userloaded firmwareconfigurationOutput Lookup TableBayer Mosaic FilterBi-Color Conversion (for TDALSA P4)Table 22: Board SpecificationsHost System RequirementsXtium-CL PX4 DimensionsApproximately 4 in. (10 cm) wide by 4 in. (10 cm) highGeneral System Requirements for the Xtium-CL PX4• PCI Express Gen2 x4 slot compatible;(will work in Gen1 x4 slot with reduced bandwidth to host)• On some computers the Xtium-CL PX4 may function installed in a x16 slot. The computerdocumentation or direct testing by the user is required.• Xtium-CL PX4 operates correctly when installed in a multi-processor system (includingHyper-Threading multi-core processors).Operating System SupportWindows XP, Windows 7 and Windows 8, each in either 32-bit or 64-bitEnvironmentAmbient Temperature: 10° to 50°C (operation)-40° to 75°C (storage)Relative Humidity: 5% to 90% non-condensing (operating)0% to 95% (storage)MTBF @40°C 36.4 yearsTable 23: Environment SpecificationsNote: Ensure adequate airflow for proper functioning of the board across the entire temperaturerange of 10 – 50°C . Airflow measuring 80 LFM (linear feet per minute) across the surface of theboard is recommended.Power Requirements during Acquisitions+3.3V: 1A+12V: 0.33ATable 24: Power Specifications
