Danfoss ECL Comfort 296 Operating Manual

Also see for ECL Comfort 210: Installation guide User guide Installation guide Installation guide Operating guide

Danfoss ECL Comfort 296 Operating Manual Manual pdf 59 page image

4.0 Settings overviewFor factory settings and setting range, see appendix “Parameter ID overview”.Parameters indicated with an ID no. like "1x607" mean a universal parameter. x stands for circuit / parameter group.Setting ID Page Factory settings in circuit(s)1 2Heat curve 63Ext. desired T 64Actual (actual flow or power) 78Wind actual 82Extended heat cut-out setting 109Extended winter cut-out setting 109Desired T (Desired flow temperature) 1x004 65ECA addr. (ECA address, choice of Remote Control Unit) 1x010 99Auto saving (saving temp. dependent on outdoor temp.) 1x011 84Boost 1x012 85Ramp (reference ramping) 1x013 86Optimizer (optimizing time constant) 1x014 86Adapt. time (adaption time) 1x015 68Demand offset 1x017 99Des. T Comfort 1x018 66Des. T Saving 1x019 66Based on (optimization based on room / outdoor temp.) 1x020 87Total stop 1x021 87P exercise (pump exercise) 1x022 100M exercise (valve exercise) 1x023 101Actuator 1x024 91Pre-stop (optimized stop time) 1x026 88Con.T, re. T lim. (Constant temperature mode, returntemperature limitation) 1x028 73DHW, ret. T limit 1x029 73Limit (return temp. limitation) 1x030 74High T out X1 (return temp. limitation, high limit, X-axis) 1x031 74Low limit Y1 (return temp. limitation, low limit, Y-axis) 1x032 74Low T out X2 (return temp. limitation, low limit, X-axis) 1x033 74High limit Y2 (return temp. limitation, high limit, Y-axis) 1x034 75Infl. - max. (return temp. limitation - max. influence) 1x035 75Infl. - min. (return temp. limitation - min. influence) 1x036 75Adapt. time (adaptation time) 1x037 75P post-run 1x040 101P demand 1x050 101DHW priority (closed valve / normal operation) 1x052 102Infl. — max. 1x057 82Limit (compensation temp., 1. point) 1x060 95Adapt. time (adaptation time) 1x061 95VI.LG.H4.02 © Danfoss | 2017.05 | 59Operating Guide ECL Comfort 210/296/310, application A230