Danfoss FC 300 Programming Manual

Also see for FC 300: Operating instructions Instruction manual Design guide Design guide Design guide

Danfoss FC 300 Programming Manual Manual pdf 190 page image

2.17. Parameters: Data Read-outs2.17.1. 16-** Data ReadoutsParameter group for data read-outs, e.g. actual references, voltages, control, alarm, warning andstatus words.2.17.2. 16-0* General StatusParameters for reading the general status, e.g. the calculated reference, the active control word,status.16-00 Control WordRange: Function:0 * [0 - FFFF] View the Control word sent from the frequency converter via theserial communication port in hex code.16-01 Reference [Unit]Range: Function:0.000 * [-999999.000 -999999.000]View the present reference value applied on impulse or analogbasis in the unit resulting from the configuration selected in par.1-00 (Hz, Nm or RPM).16-02 -200.0 - 200.0 %Range: Function:0.0% * [] View the total reference. The total reference is the sum of dig-ital, analog, preset, bus, and freeze references, plus catch-upand slow-down.16-03 Status WordRange: Function:0 * [0 - FFFF] View the Status word sent from the frequency converter via theserial communication port in hex code.16-05 Main Actual Value [%]Range: Function:0%* [-100 to +100%] View the two-byte word sent with the Status word to the busMaster reporting the Main Actual Value.16-09 Custom ReadoutRange: Function:0.00unit*[x.xx - x.xx unit] View the value of custom readout from par. 0-30 to par. 0-322. How to Programme FC 300 Programming Guide190 MG.33.M2.02 - VLT ® is a registered Danfoss trademark2