Danfoss FP735Si User Manual

Also see for FP735Si: Installation guide Quick guide Easy user guide

Contents

Danfoss FP735Si User Manual Manual pdf 11 page image

Danfoss Heating 11GBIn 24 hour mode (Fig. 9) you can enterone set of programmes which repeatsevery day (see page 14).Note: No days of the week are shown inthe display.Fig. 9Note:Event times cannot be set out of sequence.To return to RUN mode at any time, press and hold PROG.Alternatively, do not press any buttons and the unit will automaticallyreturn to RUN after 2 minutes.Your installer will have set your unit to operate with either 2, 4 or6 events per day. This will determine the number of events per daythat you are able to programme.1.7.1 Changing ZonesThe FP735Si is a 3 Zone timer and can schedule individual times toswitch each Zone of your Central Heating and Hot Water system. Toview or set the on/off schedule for each Zone the correspondingChannel number must be showing on the display.a) Press the CH button to change the currentlyviewed Zone identified by the channel numberin the display (Fig 10).b) Press the CH button again to scroll through theZone channels 1 to 3Note:Each Zone will correspond to a different area of your heatingsystem and / or hot water. Which Zone belongs to which Channelof the FP735Si depends on the installation wiring, details of whichcan be obtained from your installer. It is recommended that this isnoted in the supplied Quick Guide for future reference.Fig. 10