1.3.8 Control TerminalsIP20 380-480 V 0.37-22 kW:130BB622.10Illustration 1.4 Location of Control Terminals1. Place a screwdriver behind the terminal cover toactivate snap.2. Tilt the screwdriver outwards to open the cover.IP20 380-480 V 30-90 kW.130BB624.101. Place a screwdriver behind the terminal cover toactivate snap.2. Tilt the screwdriver outwards to open the cover.Digital input 18, 19 and 27 mode is set in 5-00 Digital InputMode (PNP is default value) and digital input 29 mode isset in 5-03 Digital Input 29 Mode (PNP is default value).Control terminals:Illustration 1.5 shows all control terminals of the frequencyconverter. Applying Start (term. 18), connection betweenterminal 12-27 and an analog reference (term. 53 or 54and 55) make the frequency converter run.18 1912 20 5527 29 42 45 50 53 54DIGI IN/OUTDIGI IN/OUTDIGI INDIGI IN61 68 69 NPCOMM. GND+24V0/4-20mA A OUT / DIG OUT 0/4-20mA A OUT / DIG OUTCOM A INCOM DIG IN10V/20mA IN10V/20mA IN10V OUT130BB985.10BUS TER.OFF ONIllustration 1.5 Control TerminalsQuick Guide VLT® HVAC Basic Drive Cascade Controller Quick Guide10 MG18F202 - VLT® is a registered Danfoss trademark11