Danfoss PK37 Quick Manual

Also see for P11K: Operating instructions

Contents

Danfoss PK37 Quick Manual Manual pdf 13 page image

1.4 Programming1.4.1 Programming with the Local ControlPanel (LCP)NOTEThe frequency converter can also be programmed from aPC via RS-485 com-port by installing the MCT 10 Set-upSoftware. This software can either be ordered using codenumber 130B1000 or downloaded from the Danfoss Website: www.danfoss.com/BusinessAreas/DrivesSolutions/softwaredownload1.4.2 Local Control Panel (LCP)The following instructions are valid for the FC 111 LCP. TheLCP is divided into four functional sections.A. Alphanumeric displayB. Menu keyC. Navigation keys and indicator lights (LEDs)D. Operation keys and indicator lights (LEDs)BackCom1-20 Motor Power[2] 0.12kW-0.16HPSetup 1AB11213 14 1511111098765432CDStatus MainMenuQuickMenuHandOnOKMenuOffResetAutoOnAlarmWarnOn130BB765.10A. Alpha Numeric DisplayThe LCD-display is back-lit with 2 alpha-numeric lines. Alldata is displayed on the LCP.A number of information can be read from the display.1 Parameter number and name.2 Parameter value.3 Set-up number shows the active set-up and the edit set-up. If the same set-up acts as both active and edit set-up,only that set-up number is shown (factory setting). Whenactive and edit set-up differ, both numbers are shown inthe display (Setup 12). The number flashing, indicates theedit set-up.4 Motor direction is shown to the bottom left of the display– indicated by a small arrow pointing either clockwise orcounterclockwise.5 The triangle indicates if the LCP is in status, quick menu ormain menu.B. Menu KeyUse the menu key to select between status, quick menu ormain menu.C. Navigation keys and indicator lights (LEDs)6 Com led: Flashes when bus communication is communi-cating.7 Green LED/On: Control section is working.8 Yellow LED/Warn.: Indicates a warning.9 Flashing Red LED/Alarm: Indicates an alarm.10 [Back]: For moving to the previous step or layer in thenavigation structure11 Arrows [▲] [▼]: For maneuvering between parameter groups,parameters and within parameters. Can also be used forsetting local reference.12 [OK]: For selecting a parameter and for accepting changes toparameter settingsD. Operation keys and indicator lights (LEDs)13 [Hand On]: Starts the motor and enables control of thefrequency converter via the LCP.NOTETerminal 27 Digital Input (5-12 Terminal 27 DigitalInput) has coast inverse as default setting. This meansthat [Hand On] will not start the motor if there is no24 V to terminal 27. Connect terminal 12 to terminal27.14 [Off/Reset]: Stops the motor (off). If in alarm mode thealarm will be reset.15 [Auto On]: frequency converter is controlled either viacontrol terminals or serial communication.Quick Guide VLT® HVAC Basic Drive Cascade Controller Quick Guide12 MG18F202 - VLT® is a registered Danfoss trademark11