Danfoss TP2 Installation & User's Instructions

Contents

Danfoss TP2 Installation & User's Instructions Manual pdf 3 page image

QBATTERY REPLACEMENTWhen the batteries approach the end oftheir life, a battery symbol blinks in thedisplay (Fig.10.). When this symbol appearsboth batteries should be replaced with highquality alkaline cells. 15 days after thebattery symbol starts to blink, the thermostatwill switch off. While the battery symbol isblinking the batteries may be changedwithout loss of time or programme.Have the new batteries unwrapped and ready, slide the batterycover fully off to the left, remove the old batteries and insert thenew ones WITHIN ONE MINUTE. Replace and slide close the thebattery cover. The thermostat will continue to function according tothe automatic programme. Should the display ever go blank duringnormal operation the batteries will need to be renewed, the unitreset, and the time (and day) and programmes reset if required.FACTORY PRE-SET PROGRAMMESFig.11.Fig.9.TYPICAL USER SET PROGRAMMEfor models TP4 & TP5This programme provides twoheating periods, morning andevening and effectivelyswitches the heating offduring the day and overnight.LIMITS OF ADJUSTMENT FOR TIME SETTINGSTime setting 1 can be at any time of the day or night, but wouldnormally be in the morning.Each of the time settings 2 to 6 can be at any time between theproceding setting and 1.59am.Time settings 2 to 5 can be set later than the next setting, but doingthis changes the next setting as well........E.g. changing setting 2 in any of the above to 3.00pm would alsochange setting 3 and 4 to 3.00pm.This feature prevents times being set out of sequence. If you wish toreturn to the pre-set programme reset the unit as described above.EVERYDAY OPERATIONWhen all six or twelve time/temperature settings have been checkedand/or altered, ensure the Programmable Room Thermostat is inthe RUN mode with the colon blinking (see Fig.1.) before slidingthe cover shut.MANUAL OVERRIDEIf you wish to temporarily change the controltemperature from the automatic setting, thereis no need to re-programme the thermostat;just press the up or down button until thetemperature you want is displayed. An up ordown arrow will appear in the display (Fig.9.)to remind you that you have over-ridden theprogrammed temperature. The unit will revertto programmed temperature at the start of the next programmedevent.CONSTANT LOW TEMPERATURE CONTROLTo set the thermosat to control at its low setting (5°C to 16°Cdepending on model) for 24 hours a day press both 2and 2buttonsat the same time. The display will show the blinking colon, the lowsetting and the snowflake symbol (fig 10). To return to the automaticprogramme press the 2and 2buttons together again.Fig.10.TP2, TP4 (Everyday) TP3, TP5 (Saturday to Sunday)TP3, TP5 (Monday to Friday)Setting Time Temp. °C Setting Time Temp. °C1 6:30am 20 1 7:00am 202 8:30am 16 2 10:00am 163 12:30pm 19 3 12:00pm 194 1:30pm 16 4 2:00pm 165 5:30pm 21 5 5:00pm 216 10:30pm 16 6 10:30pm 16Setting Time Temp. °C1 6:00am 212 9:00am 53 12:30pm 54 1:30pm 55 4:00pm 216 10:00pm 5

/ 4

Related manuals for Danfoss TP2